-
Anonymous users2024-01-23It's better to replace! Otherwise, you can use AB glue to try it, it works very well, remember to use it according to the manual! Call to buy the real thing, there are a lot of fakes! You can make up for it a few more times! A few bucks! $10!
-
Anonymous users2024-01-22Find a repairman or tie it with duct tape.
The bottom of the riser pvc110 tee is 30-35 cm away from the top plate surface, the expansion joint is installed below the tee, the floor drain and shower are all using the S bend with a cap, the basin is installed with a 90-degree cap elbow, and the S bend can be deodorized when installing the basin on this floor, and the kitchen sink drainage branch is installed on this floor, and the P bend with a cap is directly installed, I hope it can help you. It should also be noted that the smaller the distance between the tee and the top, the greater the net height of the bathroom.
Yes, it is noisy. It should not be used near the dormitory. Hospital wards, nursing homes, should not be used.
You can ask a plumber to disassemble it and reinforce it, or buy a bucket of special construction glue where it can't be disassembled, and properly extend the pipe wall to fall down where it can be disassembled.
Wrap the pipe with a wooden core board first, and then cut off the buckle strings around the aluminum gusset, as long as the large surface, so that you can 1 The sewer riser is generally paved with tiles after bricklaying, and the pipe is wrapped in the inside of the tile. 2 Launching crane.
It is difficult to replace the trap in the toilet because it involves penetrating the floor slab and also considering waterproofing.