-
Anonymous users2024-01-23This is due to the fact that the drain valve is not closed tightly. Caused by a slight internal leak. You open the tank lid. Straighten the lifting rod (water discharge) to the middle of the tank. It's going to be fine. If it is monolithic, it is necessary to replace the intermediate drain valve assembly.
-
Anonymous users2024-01-22There is limescale in the toilet sink, which causes the plastic pressure pump to not float properly, and it keeps leaking when the water is almost full. When it leaks, there is a sound, and after the leak, the pressure pump falls again, and after a while, the water fills again, and then it starts to leak again.
It is recommended that you go to the supermarket to buy a limescale ball, a few dollars, and throw it for half an hour.
-
Anonymous users2024-01-21It's the flushing tank, the automatic switch is out of order,,, if it's the toilet sounding, it's the septic tank gas running out of the toilet.
-
Anonymous users2024-01-20It is estimated that the water is leaking, close the figure-eight cutting door below and it will not sound, and wait for time to check the water switch inside.
-
Anonymous users2024-01-19That's because it's adding water, and if it's full, it won't be added, so it won't ring.
Lift the lid at the back and press the two plates in the cylinder by hand to return one of the valve plates below.
Look at the floats, sometimes they get stuck. The quality is not good. If it doesn't work, change it.
There is no buzzer in the flush toilet, and the constant screaming is that the inlet valve cannot be closed, and the sound of vibration is generated. You can try to adjust the water level positioning mechanism of the inlet valve (there are many types that cannot be listed one by one), you can go to the Wujiaohua store to find the same product, and consult the method of adjustment.
If the water supply switch pad is broken, or the debris is blocked, you can buy a new set of replacement at the plumbing store, less than 20 yuan, or disassemble and repair.
It has nothing to do with the float, the flowing water that can be seen generally flows out of the tank, and the float is in charge of the water entering the tank, the float valve. It is the leakage caused by the lack of tight sealing of the water outlet corresponding to the middle half red and half blue press the water outlet switch, you can close the corner valve at the back of the toilet tank, empty the water tank, clean it up, and the inside is dirty.