How to make the rounded corners on the edges of furniture

Arc the place when doing this (one of the practices).

1. Grassroots: The wooden keel is sawed next to each other with a saw Relatively dense saws The spacing of the saws must be even, which is related to the smoothness of the arc, but do not cut off Leave a little bit After sawing, slowly bend up and fix the four corners The arc should be the same Finally, all the arcs are connected with the keel of the same thickness The skeleton has been done for a long time.

2. Surface layer: nail the nails with a panel package (the inside and the outside are the same as the panel package) 3. Paint: The common one is to make white enamel paint.

This kind of wood is relatively low in cost, very economical, and then there are other methods, mainly in the grassroots method, the surface layer is the same.

If you make it yourself, you can basically use the Ousong board, and there is no other way on the market.

And if it is made in batches, then it is to do MDF laminated film modeling.

IF YOU'RE MODELING IN 3D, JUST MAKE A ROUNDED SQUARE, THEN OUTLINE IT TO THE THICKNESS YOU WANT, AND THEN EXTRUDE IT.

Carpentry is bent with 5 clam boards (according to the thickness to be stacked, it is best not to exceed 4 layers), and 3 clam boards are pasted on both sides.

There are two kinds of processes for making frames, one is the V groove and the other is the U groove, which belongs to the U groove.

Generally, there is a point that sells bends.

And then the rest is gluing.

If you do it yourself, the equipment is more troublesome.

It is a high-temperature stamping machine.

Humidification, then high temperature pressurization, and finally drying and molding.

Then do the surface treatment of spraying.

These shapes are generally made of wooden boards

Now this kind of modeling wood is rarely made with solid wood mortise and tenon technology, because the general wood is relatively soft and cannot withstand the mortise and tenon joint, and the hardwood is more expensive.

Therefore, it is common to use wood chip extrusion gluing; It is to unscrew the thin wood chips from the wood spinning machine, cross layer by layer on the mold tire, glue and compact layer by layer, remove the mold tire after the glue is dry, that is, get the wood blank, repair the blank and save putty to polish and spray paint.

It's very simple for us to mechanize production, and there are different processing methods according to different materials and requirements.

Wooden boards, decoration or woodworking shops are selling, but they are softer, ask the people in the store and they will give it to you, and the woodworking master knows it

Arc places when doing so.

One of the practices) 1, grassroots: the wooden dragon searches the front bones with a saw next to each other.

Comparatively dense saws.

The spacing of the saws must be even.

This is related to the sleek talk of the arc.

But not sawn.

Leave a little bit. After sawing, slowly and vigorously bend it up.

Fixed. The four corners of the arc Shiqing should do the same.

Finally, all the arcs are connected with keels of the same thickness.

The skeleton has been done for a long time.

2. Surface layer: with panel package.

Row of nails to nail well (the inside is the same as the outside.)

are all with panel packs).

3. Paint: The common one is to make white enamel paint.

The cost of this kind of wood is relatively low.

Very economical. Secondly, there are other ways.

The main thing is that the approach at the grassroots level is different.

The surface layer is all the same.