What should I do if the toilet leaks?

1. Take away the lid on the toilet, check whether the small ear pressed by the hand when flushing is stuck, under normal circumstances, the ear will bounce back to its position by itself), if it is stuck, the rubber gasket below cannot be reset, and the water has been flowing. (It may be that the screws fixing the ears are too tight or there are foreign objects plugged or the rubber transmission shaft connected to the ears is deformed, loosen the screws or remove the foreign objects, or correct and replace the transmission shaft.)

2. Look down the rubber shaft to see if the rubber gasket below (black, round diameter of about 6 7 cm, easy to find) is stuck by foreign objects, and it is normal to press it flat on the toilet drain, and remove the foreign body to solve it. Sometimes the length of the chain connecting the transmission shaft and the washer is not suitable, and the chain also has the opportunity to be hung by the tank parts, or pressed by the washer, resulting in the washer can not be reset, and the length of the chain can be adjusted.

If there is no problem with the above, it must be that the rubber gasket is seriously deformed, and the gasket is replaced to solve the problem, about 5 yuan.

In this case, it may be that there is a problem with the mediation valve, try to press the button more often to see if it still flows when the water is full. If the flow is completely broken, go with an adjustable lower float valve.

Hello, first check whether the water tank has leaks, if there is a glass glue plugging, the general building materials market is sold, waterproof is super strong; The point is that the blue cylinder valve inside you is going to be replaced.

Thank you for adopting.

After looking at your pictures, to be honest, it is because the quality is too poor, it is recommended that you replace the inlet valve and drain valve in a complete set. The problems that may exist in the previous generation of simple water parts of the previous generation are as follows: 1. The drain valve is pressed down, only the button of the water tank cover rebounds, but the drain key of the drain valve is stuck and it is not good to rebound, and the simple temporary solution is to press a few times after each flush!

2, it may be the water inlet valve on the left of the figure It has been invalid for a long time, and your simple float can't seal the water after a long time! The temporary solution is to wash it and lower the water level appropriately to see if it works.

I am a professional toilet repairer in Xi'an, the water tank does not store water, indicating that the problem is in the drain valve, and the drain valve can be replaced.

The toilet drain can be replaced, with plastic screws.

Your toilet has a stomach problem. I can't keep anything in my stomach. Fasting for 8-12 hours is recommended. Into the tank to several generations of Smecta.

I've also encountered this situation, don't be nervous, it's nothing, it's just a small problem, you don't need to replace it with a new one, just pay attention to it when you run out. Whenever you are convenient, press the flush valve, you pay attention to the sound of water storage, because the sound of continuous flushing and the sound of flushing while storing water is different, press the flush button a few more times,-- good time is when you press the water button will have a heavier feeling,-- if the water continues to come out is bad--- then you press the button a few more times, you can shake it, and then you will get off the blue lid, you can study it a little. Special reminder, be sure to ensure that you can't run water for a long time, otherwise the water bill is a trivial matter, and the water flowing on the toilet will produce scale, which cannot be brushed off at all.

Thank you for adopting.

It's best to buy Geberit's best water parts in the world.

There's a film there's in your tank, and you just put it away.

If it still doesn't work, you can change the film for 10 yuan.

I'm going to change the thing inside, but I don't know what it's called, I'm sorry, but you can go to the place that sells sanitary ware and ask the hardware store.

It's the water in the tank that floats bad, and it's OK to replace it.

Just change the flange under the toilet.