-
Anonymous users2024-01-23One. Toilet tank repair method.
1.Let's talk about it first, let's open the toilet tank first, and let's see what level the scoop inside the tank is at when it is full of water. But if the water inside is full and the tank is still flooding, then it must be leaking.
2.Next, we use water to pull the card position of the water scoop up and down, but look at the sensitivity of the water scoop, but if there is a problem, or it is difficult to move, then it is declared that the water scoop equipment has failed. Remember to press the ladle down a little bit, not too high.
3.So we can remove the equipment of the water scoop and clean it, if we don't know how to disassemble it, just put dry water directly in the water tank, and then use dish soap and laundry detergent to clean it once. However, if you can continue to use it, if it doesn't, you need to replace it.
4.Then let's talk about it, check the outside of the water tank, the interface of the stainless steel hose at the position where the water tank is connected, but see if it is not tightened or the rubber pad inside is aging and causing water leakage. This must be ascertained.
5.When we are repairing, if the internal equipment is fine, then we also need to check whether the toilet tank has the problem of cracking caused by impact, and if there is an external force, the water tank may also have the problem of water leakage.
Two. How to buy a toilet.
1.In fact, when we buy a toilet, we can set the weight of the toilet as a standard, but the heavier the toilet, the better, but its material is relatively better, and you can properly weigh the weight of the water tank lid to see how the toilet is when purchasing.
2.However, when purchasing a toilet, we should pay attention to the number of sewage outlets in the toilet, and it is better to choose one sewage outlet, but because multiple sewage outlets will affect the impact force of drainage, which is not conducive to draining clean.
3.There is also a need to see the size of the diameter of the internal drain of the toilet, but when purchasing, it is best to choose a larger diameter and the toilet bowl has glazed inside the best.
4.Finally, when buying a toilet, we should also pay attention to the flushing method of the toilet, but the flush type and siphon flush type have a water injection of 6 liters, and the sound is relatively loud. The siphon vortex uses more water, but it is quieter.
(1) Check whether the tap water pressure is too low.
2) Check whether the filter screen of the inlet valve is blocked by debris. >>>More
1. Leaking water from the toilet lid is a common problem, so don't worry too much when this problem occurs. First of all, we can open the lid of the toilet bowl to see what position the horizontal line of the internal scoop is when the toilet bowl is full of water. If the inside of the lid is already full of water, but the water does not stop entering the lid, then the lid must be leaking. >>>More
There are three situations in which a small amount of water leakage can occur: >>>More
It is estimated that the inlet valve is aging and deformed and can not close the water, lift the pontoon of the inlet valve up, if you can close the water, you can try to adjust the water level of the water tank yourself, and the overflow pipe in the middle of the water tank is OK, otherwise you need to replace the inlet valve. The labor cost and material cost of door-to-door maintenance in various places are different, and the accurate price cannot be provided, and the service fee of general skilled workers is the one-day wage of migrant workers who can only contribute.
First of all, I opened the water tank of the toilet, and I saw what level the water inside the water tank was on when it was full. If the water inside is full and the tank is still flooding, then there must be a leak coming out. >>>More