Toilet toilet problem

Updated on Toilets 2024-03-03
4 answers
  1. Anonymous users2024-01-23

    Remove the toilet, remove the broken cement, and then re-apply the cement to the area covered by the toilet bowl and place the toilet bowl on top. (The holes should be aligned when putting it on), and it can be used again after two days of drying.

  2. Anonymous users2024-01-22

    It's okay.. Don't toss it anymore. Use with care.

    Otherwise, it's open... The flush will flow out.

    If only I could move. You go to the toilet repair worker. Realign the sewer with cement.

  3. Anonymous users2024-01-21

    Generally, the quality of the cement is substandard, or the construction is cut corners.

    Get the cement again.

  4. Anonymous users2024-01-20

    No, I would advise you to reglue.

Related questions
1 answers2024-03-03

The upper link is, the toilet is so big, and the lower link is, this cowshed is not small.

4 answers2024-03-03

The trick to quickly unclog the toilet bowl is very practical.

5 answers2024-03-03

It's not the toilet that is the fault, it's the septic tank that's full, and the land where I rented a house also appeared, and the landlord was asked to get it done. It may be blocked, the detection method is to take a basin of water and flush it directly, so that it is not blocked, otherwise it is blocked. 2. If it's not blocked, it's the toilet itself. >>>More

1 answers2024-03-03

It should be said that if you put a little more water yourself, it will solve the problem... Siphon needs to consider the following (whether the reserved space is large enough. These can ensure the amount of water that follows... >>>More

2 answers2024-03-03

The toilet is installed with a pure water bay, no problem, the toilet is also equipped with a sealing ring, why does it still smell? That's in the pipeline.