How to change the switch of the toilet inlet pipe when it is broken?

1. First of all, remove the upper lid of the toilet tank.

2. Then take a closer look at the simple structure in the toilet tank.

3. At this time, you can see the whole picture and working parts of the toilet tank inlet valve.

4. Then turn off the water inlet switch, drain the water in the toilet tank, unscrew the water inlet pipe joint with a wrench and rotate the plastic screw cap of the water outlet pipe by hand.

5. Finally, take out the toilet inlet valve switch and replace it with a new one.

Notes: Before disassembling the toilet inlet pipe, you should prepare a water inlet valve set to be reinstalled, as well as items such as common screwdrivers. Then it is necessary to make preparations and turn off the water inlet switch under the toilet tank, so that no more water will enter it, so that the water inlet network pipe can be replaced later.

It's no longer just about draining the toilet tank with water.

Both ends of the water inlet pipe need to be installed, and the one end connected to the water pipe is the water inlet connected to the toilet. Therefore, before connecting the water inlet, it is necessary to make sure that the main gate of the water pipe must be closed.

First of all, you should check the specific model of the toilet at home and the specific diameter of the water pipe, so that you can buy the corresponding matching products.

Then the toilet bowl is cleaned to drain the water inside. Put some soft items on the toilet seat.

At this time, it is time to replace the operation, first remove the fixtures on both sides of the pipe, and then remove all the wires on the pipe and the old pipe. If the water pipe is aged, it will become very fragile, so be careful when removing the water pipe.

Then the new pipe is connected, and the glue must have a certain thickness, so as to ensure the normal connection of the pipe.

The last step is to tie the fixed iron ring firmly on the pipe and the connector, and the whole installation process is completed.

First close the main valve of the water intake, prepare a triangle valve, a roll of raw meal belt, a 300 live wrench for the tool, and then remove the leaking water and replace it with a new one.

1. If the pipe is broken, then replace the pipe (hose).

2. If the valve (switch) is broken, then close the main valve first, and then use a wrench to remove the broken valve and reinstall the new valve.

3. The tools needed are: movable wrench, raw material belt.

First go to the hardware store to buy a triangle valve, then close the water gate, prepare a movable wrench, a roll of loose material tape, you can change it!