-
Anonymous users2024-01-23It's still as big as it gets, and the big or small door can only open half of the door、、、 forget to adopt it.
-
Anonymous users2024-01-22When it is made into a sliding door, you don't have to think about one big and one small problem.
-
Anonymous users2024-01-21It is better to make two doors of the same size to look more beautiful.
-
Anonymous users2024-01-20Probably not, how can you push it when you're done?
If you want to suspend the ceiling, the use of polymer composite ceiling or aluminum gusset ceiling, will cause the width of the edge strip to have a significant size, it is recommended to use gypsum board and other shapes to decorate the ceiling, can avoid the obvious situation that one side is large and one side is small.
The door is now custom-made, you should consider the door cover, you can thicken the left wall with the right side, so that the door cover will look much better, or on the right side from the new base layer to make a left side of the same wide door cover, so that this is a little less aesthetically pleasing to the right, there is a gap on the right, the door set is a symmetry, aesthetics.
Do you mean to say that the meter is in a zigzag shape to do a sliding door? Is there only a large amount of space under your cabinet that is ready to waste a lot of space? Not many designers would recommend you to do this, because then the space under the cabinet would be a waste of money.
You didn't say how wide it was on both sides of the door, how wide were the refrigerator cabinets? Then I'll just say from the door, Three Mountains! But as for whether the fan is dead or alive, I can't say.
There are pros and cons. The trackless track is not installed and does not occupy the upper and lower space, but it usually deviates and deforms after a long time. And the railed ones are just the opposite.