What to do if the toilet is leaking

The solutions to a leaky toilet are as follows:

>1. The seams should be painted in place.

The joints between the walls and floors of the bathroom and the joints between the water and water pipes and the floor are prone to problems. In the construction, we must urge the workers to deal with these corners and corners, and all the waterproof coatings must be applied "in place".

2. Wall treatment is also very important.

In the general toilet waterproofing treatment, the wall should also be made about 30 cm high waterproof paint to prevent water from penetrating the wall. However, if the wall of the bathroom is a non-load-bearing lightweight wall, the entire wall should be coated with waterproof paint. If you use two shower screens, the two walls that are connected to each other should also be fully painted.

3. Level the bathroom floor first.

If you want to replace the floor tiles in the bathroom, after chiseling off the original floor tiles, you must first level the floor with cement mortar, and then do waterproof treatment. This avoids leakage of the waterproofing coating due to uneven thickness.

4. The waterproof test must be done.

After the construction of the toilet is completed, all the sewer in the toilet is blocked, and a 25 cm high "barrier" is built at the door, and then 20 cm high water is poured into the bathroom. After 24 hours, check the surrounding walls and floors for leakage. This 24H waterproof experiment is the key to ensuring the quality of toilet waterproofing projects.

5. Keep the water smooth.

All sewer pipes in the bathroom, including floor drains and sewer pipes for sanitary ware, should be kept unobstructed. Only in this way can we fundamentally avoid the tragedy of the "flooding of the Seventh Army."

Toilets

A toilet is a place built by humans for physiological excretion and excrement. Most of the toilets used by humans are divided into men's and women's toilets. There are many names for toilets, some are called thatched houses, some places are called cellars, and the more elegant ones are called toilets, and the foreign name is Toilet.

If you can confirm that it is not a leaking pipe, you can fix it from below! Ordinary people can't do a good job of repairing the backwater! Provide free professional waterproof leakage technical consultation!

If you want to repair directly on the surface, it is recommended that you use it.

Swiss Sika Leak Resistant Membrane or Sika Transparent Water Repellent Treatment or Sika Rain Repellent Agent.

Just follow the instructions and you're good to go!

Surface repair is only a palliative but not a cure, and surface treatment can only be managed for a certain period of time.

The most fundamental way is to open the brick and redo the waterproof!

First of all, it is necessary to rule out whether the leakage is due to surface penetration, and to rule out the seepage of sewers, water pipe channels or buried water pipes. You can choose to use the waterproof wall of the guest forest to do the waterproof treatment, and the waterproof treasure of the guest forest wall.

1.Excellent permeability to form a waterproof layer on the surface;

2.The coating is tough and strong, high temperature and frost resistant, no shrinkage or expansion, excellent water resistance, weather resistance and durability;

3.Colorless and transparent, no coloring, no adsorption of dust and ash;

4.The construction is convenient and not limited by the geometry of the base layer.

The construction operation is very simple, no need to chisel bricks and knock bricks, and after the wall is dry and clean, it can be evenly painted.

Water seepage in kitchens and bathrooms is often infiltrated through brick joints, and the integrity and protection of tile joints is the key to waterproofing.

If it is not a problem of floor heating, planing bricks, redoing waterproofing, if it is a problem of floor heating, you should look for things to see, do it yourself, find a professional person, it is safer.

Replace the floor tiles with new ones, and then find a worker to put on a layer of asphalt after the floor is dug up.

This one is the easiest, and it doesn't cost much.

This is really troublesome, and the water seepage in the bathroom is generally the place where the ring beam is in contact with the position of the lifting slab of the imitation building, which is easy to seep.

In fact, it is a hidden danger of water seepage in the building that may be caused by fixing certain objects such as lamps or toilets, urinals, etc.

It is recommended that you first determine where the water seeps out.

Then make a decision to answer the fiber!

Ground demolition is inevitable!

Buying a small bag of waterproofing agent is actually high-grade cement pre-mixed with very fine quartz sand. About 1 kilogram, 15 yuan. If the color of the cement is dark and affects the overall appearance of the bathroom, there is also a white tile caulk, which looks the same as white ash, and is produced in Tianjin, a small bag of 10 yuan a kilogram.

Both are similar in terms of usage: mix them with water to form a sticky paste and rub them over the gaps. Finally, wipe it with your index finger, and then stick it to the tile next to it and wipe it off with a dry rag after it dries slightly.

After a little waiting, the water gradually decreases and there is no need to repair it. The trend is not reduced, and it needs to be repaired, but don't be so blind when repairing, carefully suppress and test the water, and only after determining can the wall or ground be restored.

The solution: if the sewer pipe is cracked, replace it, if it is a crack in the floor tile, you can use silicone, so that you don't have to smash the floor, but applying silicone is not a long-term solution.

You can remove the tiles in the waterproof part of the door (you can extend inward to remove a few more pieces) and redo the waterproofing. Then do a 24-hour water storage test, the water storage height is the highest 20 30mm, if the inspection is qualified to carry out the laying of tiles, pay attention to the new waterproof layer must be protected in the paving process, so that we can avoid the second water storage test. However, if the water storage test finds that the waterproof layer is still leaking, then there is no way to remove all the bathroom floors and re-do them all waterproofing.

Thorough method: Remove the floor tiles and the bottom layer of rotten wall tiles, remove the floor tiles to expose the original ground, and use double groups.

Parts of the waterproof mortar to do, and then do a 24-hour closed water test to check whether there is water leakage downstairs, if there is a problem.

Continue until it doesn't leak.

If the urinal is broken, you must change to a cheap pool, but at the same time as changing the urinal, you must also do a good job of waterproofing the ground, if you don't do a good job, it will still leak, pay attention to the place where the jujube slag is finished, and the interface between the urinal stool and the flush pipe must be blocked with cement or other machine materials, otherwise this place is the easiest to leak, and if it is a settlement toilet, you can drill a few small holes under the floor drain pipe, so that the water of the settling plate is discharged from the sewer pipe and will not stop at the settling board. There will be no water leakage.

Like your problem, the original waterproof did not do the atrophy in place, may not have been done, poured to the urinal broken, the water flowed down, but this is not a direct reason, you must re-do the ground waterproofing, knock off the tiles, brother with Xiang this time, you Pei Bo can be optimistic, it is best to buy your own materials, buy a good waterproof material, otherwise the next time it will leak a big one.

Just change the urinal.

If it's broken, it's good to change it.,Try to hurry.,If your problem downstairs can't wait to go to the management office to find someone to talk about you.。

Find those who post advertisements in the community: toilets, sewers to deal with it, notify the downstairs neighbors to cooperate before work, it doesn't cost much! It is not recommended to do it yourself, professional people do professional things, which is the fastest way to solve the problem.

If the pipe leaks, you can only change the pipe, if the upstairs waterproofing is not done, you can find the resident and ask him to do the waterproofing again. The water leakage in this place falls under the scope of property management. You can find the property to repair it.

Just change one, go to the pipe store and buy one and replace it, isn't it over? How simple?

You can only find a builder to replace it, but winding it with raw material tape can also solve the problem.

To tell you the easiest way, buy a plastic steel clay, and then plug the surface of the PVC pipe to ensure that there is no leakage. You can do it yourself, the material is more than 10 yuan, and the operation method is as instructed.

If you want to do this, you should find a property company, no more real estate company, no more media exposure, and legal means. If you haven't renovated yourself, the construction has not been done, but you can't go directly to the construction company. Either the property, or the real estate company,

First turn off the sluice, apply it with "502" glue, apply more, and finally use transparent glue. If you really can't do it, ask someone else to help fix it.

This is the inspection port sealing ring of the toilet sewage pipe storage bay, which is not good, just change the appropriate circle. Small details, big problems.

Call the master to fix it. Or use your 300-plus IQ to find a way to plug it.

There are generally three types of water leakage:

1. The leakage of the waterproof layer is manifested in the serious leakage downstairs after bathing or using water on the ground, and the downstairs performance may be one or more places. The judgment method is very simple, plug the floor drain, and then release water on the ground, pay attention to the observation of the water leakage downstairs after 40 minutes, if the water leakage downstairs is serious, it is determined that the waterproof layer is leaking. In this case, you can find waterproofing on the Internet, use waterproofing agent, caulking paste, and plastic steel mud to repair.

That is, the surface of the bathroom is waterproofed again, without planing tiles, saving time and cost.

2. The sewer pipe is leaking, which is manifested around the sewer pipe, and there is a serious dripping phenomenon. The way to judge is to drain the floor, the hand basin, fill the water, and repeatedly flush the toilet, and see the aggravation of the water leakage downstairs, it is the leakage of the sewer pipe. In this case, find a repairer to replace the sewer pipe and try to reduce the bricks as much as possible.

Then it also needs to be waterproofed under the ground rework, and there is no need to plane all the bricks. Yijia waterproof products can be used to waterproof the surface of the bathroom.

3. That is, the water inlet pipe leaks, if the water leakage is uniform and continuous, turn off the upper water, and the water will be reduced and will not leak. It means that the water pipe is broken. This situation can be solved by changing the open pipe, no need to planing the bricks, or judging the leakage point by suppression, changing the pipe is probably like this, I hope it can help you!

The first step is to determine the cause of water leakage, there are generally only two major reasons for toilet leakage, one is pipe leakage, and the other is waterproof layer failure and leakage, and the two must be one or both. There is a problem with the water pipe, the tile needs to be replaced, the waterproof layer will be destroyed, and the vibration may affect the quality of the floor slab, so the waterproof layer should also be redone with the appropriate material. If the failure of the waterproof layer alone causes water leakage, there are two options for repair

One is to smash off the tiles and redo the waterproof layer, if you choose the appropriate waterproof material, you can completely solve the hidden danger of water leakage in the future, you can do it once and for all, pay attention to the key point to choose the right material. However, the cost of doing so is very high, the bathtub, toilet, bathroom cabinet and other ancillary facilities must be removed, and it is very likely that they will be replaced. The second is to use transparent waterproof paint that does not smash bricks to paint on the surface of the tile, which is costly.