Furniture painting problems

Because I don't know how you do it, I'll summarize some possible scenarios for you:

The problem of lacquer is not uniform.

There is a problem with the material itself, and the surface is uneven.

The hygiene before painting is not done well, and there is dust.

The bottom layer is sprayed thick.

Hope the answer will be helpful to you.

If you really want to change the color difference. It can only be from a new batch of putty, and then spray paint. This one is not easy to get. And the cost is relatively high.

The process of varnish spraying Originally, the general oilers are not sure to do a good job, that is, the oilers of the furniture factory are also made with professional equipment and professional sites, we are at the construction site, and the requirements of the tools and sites are not in place. I guess the oilman is also afraid that the squirt will not be satisfactory. That's why I refused.

I recommend that you keep the color of the wood. Don't lose more than you gain. In fact, the thickness of the paint film is there.

It just feels good. It is not realistic to ask for the same color and effect as ready-made doors or furniture!

There will be such a possibility, but if the painting technology is excellent, or if the process is complete, such problems can be reduced.

In fact, it is possible, that is, now the topcoat is sanded and smoothed, and you can spray colored transparent paint. Just sanding the topcoat is a little more labor-intensive than sanding the primer, but the quality is good.

Transparent putty can only be used as a first coat paint, not a primer. Those who use transparent putty as a primer are all cutting corners, and the paint is not of quality.

What he says is the truth!

The current spray paint is not very even. If you're lucky, you won't be able to see it from a distance, but you might be able to see it up close.

If you want to spray, scrub it.

Wash off the paint with banana water and sand it to make the color. When I wash it, it's fast.

If the board is uneven, the effect of spraying out is very poor, you use paint remover to remove the varnish, and then batch putty outside.

The effect of the uneven spraying of the board is very poor.

The spray paint is uniform, but the effect is not as good as that of hand-brushing, and the brush is thicker.