How to press the installation of the living room light with remote control

The installation method of the light strip remote control in the living room is the same as the normal installation method, and we are only allowed to install the neutral line and the live wire on the corresponding interface.

Hello, the setting method is as follows: 1. Clear the code, press the two keys on the upper row of the remote control (we sent you) at the same time (don't care about the symbol of the keyboard, be sure to press it at the same time), the indicator light flashes down and goes off and then it will keep flashing, let go of your hand, that is, the code is cleared successfully. Note:

The light should keep flashing, and after the code is cleared, press each key and the indicator light will be flashed and extinguished. 2. Copy, one hand holds the original remote control and the other hand holds the purchased remote control, the two remote controls are as close as possible, and press the door opening button on the two remote controls at the same time, and the copy remote control indicator light keeps flashing to indicate that the copy is successful, and then let go of your hand. In the same way, copy the other three keys in turn.

Note: If the light does not flash when copying, after pressing the keys on the two remote controls, do not let go of both hands, and then take the copy remote control to find the signal around your own remote control, you can change several positions, such as head to head, back to back, after seeing the light keep flashing, it means that this signal has been copied. (After the remote control is copied successfully, press any key indicator light to stay on!) )

The light strip remote control, there are two kinds of installation:

The light strip comes with a control chip. It is the same as the ordinary light strip linking. After the power is turned on, the remote control switch can be used to change the light on or off, or change the color.

It is necessary to install an additional controller when installing the light strip. Turn it on or off with a remote control or switch below, or change the light.

Both installations are ballasts with a power supply directly linked to the light strip.

Look at how many ways your remote control is, it is equipped with a splitter, take three channels as an example, the splitter is divided into three, the input is two 220V, and the output is four wires, of which three live wires are connected to three groups of lights, and the other is connected to three lamps and ground wires. I hope it will be helpful to you, forget to adopt.

2.Remove the original wiring and remove the lamp.

3.Connect the power supply line of the original lamp to the live wire of the remote control switch (generally red), and connect the power supply line of the original lamp to the zero wire of the remote control switch (generally black wire).

4.The remote control switch output zero line (black wire) is connected to the outer screw line post of the lamp port, and the remote control switch output live wire (generally blue wire) is connected to the inner center line post of the lamp port. The receiving antenna (usually a white wire) of the remote control switch is spread out.

5. After confirming that all the wiring is correct, wrap the insulating tape to send the test lamp.

Question not received.

2.Remove the original wiring and remove the lamp.

3.Connect the power supply line of the original lamp to the live wire of the remote control switch (generally red), and connect the power supply line of the original lamp to the zero wire of the remote control switch (generally black wire).

4.The remote control switch output zero line (black wire) is connected to the outer screw line post of the lamp port, and the remote control switch output live wire (generally blue wire) is connected to the inner center line post of the lamp port. The receiving antenna (usually a white wire) of the remote control switch is spread out.

5. After confirming that all the wiring is correct, wrap the insulating tape to send the test lamp.

There are two kinds of light strip remote control.

The first is to have its own control chip in the light strip. It is the same as the ordinary light strip linking. After the power is turned on, the remote control switch can be used to change the light on or off, or change the color.

The second is that the light strip needs to be installed with an additional controller. Turn it on or off with a remote control or switch below, or change the light.