Illustration of how to change the toilet seat

Solution 1: When changing the toilet lid, we need to remove the fixing bolts at the back of the toilet to replace it; When installing, you can operate in the opposite direction. There is no difference in size of the general toilet seat, just adjust the two bolts when installing.

But you also need to measure the size, the distance between the screw holes, the width and length of the toilet seat, and then buy a new toilet seat to replace!

Solution 2: Go around the toilet to see where the screw cap of the toilet lid is, then choose a suitable wrench, just take off the screw cap, the position of the screw cap of the toilet lid is divided into two types: bright and dark, the bright place is easy to find, but the dark screw cap is not easy to see, the general position is set at the edge of the toilet tank, so open the lid, put your hand in, and feel the direction of the water tank to see if there is a screw cap. To install the toilet seat, you need to remove the fixing bolts at the back of the toilet, remove the previous toilet cover, and then replace the new toilet seat with a fixed screw cap.

At present, most toilet seats are large and small, as long as the screws at both ends of the toilet are done. However, the size of the toilet bowl must be measured before changing the toilet lid, and the width and length of the screw cap from the toilet lid also need to be determined. So as not to buy products that do not fit.

Solution 3: Different styles of toilet lid installation are also different, generally the bottom end of the toilet lid is connected to the position of the toilet bowl, which is screwed up behind it, as long as you reach down to find the screws on both sides of the screw, you can take off the whole lid, very simple, you can try.

Solution 4: You can find a professional to replace it for you. So how much does it cost to change a toilet seat?

If you are looking for a professional team, then the price cannot be determined, because there will be differences in the fees of each place and each person, and it is impossible to give an exact figure.

This question is very simple, you will know it after you get the toilet lid, it is generally two plastic screws, through the two holes on the top of the toilet, to the other side of the tightened fine, we are also entangled when we buy, and we can understand it at a glance after getting it.

When replacing the toilet seat, you can replace it by removing the fixing bolt on the back of the toilet bowl and operating in the opposite direction when installing. Most toilet seats are large or small, and you can simply adjust the two bolts when installing. But you also need to measure the size, the distance between the screw holes, the width and length of the toilet seat, and then buy a new toilet seat to replace!

Find the screw cap, remove it with a live handler, and replace it with a new one. Generally, the position of the screw cap is not easy to find, some are in the light, and some are in the dark. In the dark place of the screw cap, inside the toilet bowl against the side of the tank, open the lid.

If you put your hand in it and touch it upwards and in the direction of the tank, you should be able to touch it, but you can't see it.

Different styles of toilet lid installation are also different, generally the bottom of the toilet lid is connected to the position of the toilet, which is screwed up behind it, as long as you reach down to find it, the screws on both sides can be taken off.