-
Anonymous users2024-01-23The picture below is the 118 type four-position 1-open 15-hole, and the wiring method is the same as that of the nine-hole socket with switch.
1. Switch control socket.
As shown in the figure: L2 of the Firewire switch, from the L1 wiring of the switch to the L binding post of each socket, the neutral wire is connected to the N binding post of each socket, and the ground wire is connected to the E binding post (one vertical and three horizontal symbols in the circle).
>2. Switch and control the light.
As shown in the above and below figures: the live wire connects to the L binding post of each socket, the neutral wire connects to the N binding post of each socket, the ground wire connects to the E binding post (the symbol of one vertical and three horizontal in the circle), the L1 of the live wire connects the switch, the L2 wiring from the switch to the positive pole of the lamp, and the neutral wire connects to the negative pole of the lamp.
Each original five-pin socket is replaced with a five-pin switch socket. The new switch socket is first connected to socket L and switch L with square copper wire, the original three wires, the live wire is connected to the switch L1 (originally connected to socket L), the neutral wire is connected to socket N, and the ground wire is connected to socket E (there is a vertical and three horizontal symbols in the circle).
Each original five-pin socket is replaced with a five-pin switch socket. The new switch socket is first connected to socket L and switch L with square copper wire, the original three wires, the live wire is connected to the switch L1 (originally connected to socket L), the neutral wire is connected to socket N, and the ground wire is connected to socket E (there is a vertical and three horizontal symbols in the circle).
1. Ensure that the quantity is reserved.
There should be one single and multi-gang switch, which is placed on the wall in the direction of the door to control the kitchen lighting; 1 voice-activated switch, placed on the wall in the direction of the door, used to adjust the kitchen lighting. >>>More
The kitchen switch socket is sure to be very dirty and not too easy to clean up, and it is easier to choose the switch socket with better pollution resistance from the beginning, such as the Shang switch socket like Schneider Electric. In my own personal experience, I scraped some ash powder from the air conditioner outside the house and applied it to the surface of the water conditioner, and after the switch was erected, some of the ash powder fell off automatically very quickly. The residual ash powder can be cleaned and dried very quickly after being wiped lightly with a paper towel, and even if a marker is used to leave a mark on the surface of the switch, it can be wiped dry with a paper towel. The anti-fouling performance is very good. The key is that the switch can be covered with a D I Y side, and it is very easy to remove and clean.
Kitchen switches.
There should be one single and multi-gang switch, which is placed on the wall in the direction of the door to control the kitchen lighting; >>>More