Why does the tee of the toilet drain main bar click?

Updated on Toilets 2024-03-17
9 answers
  1. Anonymous users2024-01-23

    Because there is also that water or uh some excrement falling down on other floors, there will be a clicking sound.

  2. Anonymous users2024-01-22

    This is where there is a whole set of small tees before it, and this sound will appear, and it is a sound of gas and water. This is where the whole set of small tees comes in, and this sound appears, and it is a gas, the sound of colliding with water.

  3. Anonymous users2024-01-21

    Something's stuck there, and there is a sound when the water flows by.

  4. Anonymous users2024-01-20

    It may be blocked, caused by unfavorable drainage, and the sound is loud.

  5. Anonymous users2024-01-19

    The toilet sewer main-3 pass clicks, probably where the exercise can be changed.

  6. Anonymous users2024-01-18

    It is possible that there is a foreign object in the tube that is blocking the sound.

  7. Anonymous users2024-01-17

    Why does the toilet drain main -3 pass click, maybe because your tee is unqualified, the quality of the tee is not good?

  8. Anonymous users2024-01-16

    It may be blocked by air, or there may be debris.

  9. Anonymous users2024-01-15

    There must be a foreign object stuck around the corner.

Related questions
1 answers2024-03-17

The sewer tee is under the floor slab, and above the floor slab is a climbing pipe, 30cm above the ground.

2 answers2024-03-17

Find a sewer, a few dozen dollars will do.

2 answers2024-03-17

According to the degree of decoration, the height from the ground is different, the distance from the cabinet floor is 12cm, the height of the P-shaped trap is 12cm, the minimum height of the pipe center is 25cm from the forming surface, and 30cm from the blank surface. >>>More

1 answers2024-03-17

The upstairs sewer pipe, upstairs repair, it doesn't cost much, because it's downwater, there is no pressure, and it's okay to wrap it tightly with waterproof self-adhesive tape.

1 answers2024-03-17

If there is a water leak at the tee joint, remove it, wrap the raw material tape around the thread and install it again.