-
Anonymous users2024-01-23If it cannot be completely removed, the ground should be kept 10-200mm in order to fully connect with the sealing ring to avoid sewage overflow.
-
Anonymous users2024-01-22Aim the new toilet drain pipe with the sewer pipe on the ground and press it, remember to install the sealant pad, and finally seal it with glass glue and make a circle along the edge.
-
Anonymous users2024-01-21As long as the sewer pipe is flush with the ground, install a special sealing ring on the toilet drain, or put a circle of glass glue (putty) or cement mortar around it, and the ratio of cement to sand is 1:3.
Steps to install the toilet:
1. Check the leveling between the sewage pipe and the ground.
Before installing the toilet, the sewage pipe should be comprehensively inspected to see if there is mud, sand, waste paper and other debris in the pipeline, and at the same time check whether the ground of the toilet installation is level.
2. Determine the center of the sewage pipe.
Flip the toilet bowl over to determine the center on the toilet drain and draw a cross center line that extends to the bottom of the toilet bowl around the feet.
3. Fix the toilet.
Align the reticle line between the toilet bowl and the ground drain outlet, keep the toilet installed horizontally, and press the sealing ring tightly, and install the anchor screws and decorative caps.
4. Do a good job of bottom sealing.
5. Install the water tank accessories.
Drain the water for 3-5 minutes to rinse the pipes to ensure the cleanliness of the water pipes; Then install the angle valve and the connecting hose, then connect the hose with the installed tank fitting inlet valve and press the water source.
6. Debugging and inspection.
Check whether the water inlet and sealing of the inlet valve are normal, check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and whether there is leakage to install the filter device of the inlet valve.
-
Anonymous users2024-01-20The exposed part is completely removed.
After the installation of the water pipe, the pressurization test must be carried out: the pressurization test is generally carried out under the condition of double water pressure, and there should be no water leakage in the test. Regardless of these basically experienced masters, they know that the bathroom installation master who is looking for Master Wan does not need to consider these problems at all, and the more experienced master will basically do. >>>More
1. Not necessarily.
2. The flush toilet has a drain device. >>>More
Do as the master says.
Now come to the kitchen sink sewer pipe varieties are annoying, the purpose of the pipe bending is to store water and prevent smell, also known as the water storage bay, your kitchen sink sewer pipe is too long, allowing for backwater, personal opinion, is also the easiest way is to paint the white PVC pipe color part of the mourning, the gray hose can be inserted.
The toilet reserves the distance between the sewer and the wall, and the toilet selection tool can be 30 cm to 40 cm according to the room type of the toilet and personal preferences, which is relatively normal, and the strong one who can reserve 20 cm in actual operation, and the actual distance from the center line of the sewer, the actual distance of the bridge deck can be 32 cm to 42 cm, and there will actually be an error of 10 cm, which is very normal.