What should I do if the plaster line ceiling at home always loses powder, is it better to replace it

Updated on Suspended ceilings 2024-03-26
3 answers
  1. Anonymous users2024-01-23

    It is estimated that it has been used for too long before the plaster has aged before the powder has fallen, or to change the gypsum line ceiling of AIA, I use it for a long time, and there is no powder for a long time, even if the weather is humid, I am not afraid, and the quality is good.

  2. Anonymous users2024-01-22

    Change to a better quality one, and it will fall off after a while!

  3. Anonymous users2024-01-21

    The reason for the detachment of the gypsum line from the wall is that the leveling treatment of the wall is unqualified, which is a construction quality problem. Solution:

    The gap is too large, first scrape the putty on the wall, carry out appropriate leveling treatment, and then paint it.

    If the gypsum line wants to be firmly bonded, it should first be adjusted with glue to speed up the adhesive powder.

    The spacing of the installation points with the point should not be too large. What's more, after the line is angled to the corner of the wall, it must be pressed hard for more than a minute.

    It is operated with latex gloves to prevent the glass filament from pricking your hands.

    Apply the spilled quick-tack powder with your fingers to fill in the visible gaps.

    Note: Immediately after that, clean the surface of the plaster line with a brush dipped in water. After drying, it is difficult to handle the smooth water.

Related questions
2 answers2024-03-26

You can do it or not, if you don't do it, the yin and yang angles have high technical requirements for the painters, and it looks very comfortable. Good luck.

1 answers2024-03-26

The gypsum line is still better without patterns, and the traces of dust will be seen in the lines with patterns after a long time!

1 answers2024-03-26

The space required should be greater than this 41 centimeters and the minimum is more than 50 centimeters.

1 answers2024-03-26

When the plaster line is long, it can be cut with a hacksaw blade, or it can be cut with a sawsaw and a cutter for sawing wood.

3 answers2024-03-26

Hello! It is estimated that the base layer has not been dealt with well, if you want to re-do it, it is recommended that you re-do it, before scraping putty, you must roll a side of the interface agent, if there are cracks in the wall, you also need to deal with the cracks first Only represent a personal point of view, do not spray if you don't like it, thank you.