-
Anonymous users2024-01-23You can wipe it off with a hot cloth dampened with dish soap.
There are many ways to remove offset printing on smooth items at home, and you can try the following methods:
1. Use soap and a little ammonia and turpentine to mix liquid, you can remove a lot of offset printing on glass.
2. Use transparent adhesive with good viscosity to repeatedly stick and tear, and you can remove some of the surface.
3. Wipe it off with a little dilute sodium water, or use paint thinner.
4. You can use a hair dryer to dry, and then you can scrape it gently.
5. Wipe with a cotton swab dipped in nail polish remover.
6. Wipe the wind oil essence.
7. Use a special detergent or sneaker detergent to wipe it.
8. Use the 4B eraser for drawing to be very soft, and you can erase it with the Korean eraser.
9. If the traces that have been left for a long time have hardened, you can use a hot towel to soften it before wiping it.
In fact, you can find a half-inch wide bamboo strip and put it into the toilet to dredge it can solve the problem If it is greasy, then flush a basin of boiling water to melt it. Fill it with water, use the suction cup to align it with the freezer to make a piston movement, and the toilet is open in a few clicks. Go deep into the toilet, use the toilet plucker to drive it, and throw the loach in the toilet No, pour some warm water down, anyway, to stimulate it is to prepare a large bucket of water to the toilet drain to quickly fall, pay attention, the bucket should be raised higher, increase the impact, and generally can be flushed down. >>>More
Epoxy glue for ceramics and silicone can be glued. It is recommended to use one-component transparent silicone and scrape the silicone into the crack with a gray knife. Covering the cracks with a layer of silicone will do.
When the toilet pipe is blocked, you seal the toilet mouth with tape, and when you press down the tape when you press down the tape, due to insufficient air pressure to remove the blockage in the toilet, then the water pressure will press the water in the toilet bowl into the tank.
You're talking about the two eyes on the toilet base, just use white cement to adjust some water to plug it.
Can be sealed with the most common glass glue.