Difficult and difficult problems in the kitchen flue

Updated on Kitchen 2024-03-02
3 answers
  1. Anonymous users2024-01-23

    As far as I know, the flue has a compartment in the middle (as shown in the picture), and it has the difference between the main flue (upper and lower connection) and the auxiliary flue (the term subflue is not necessarily accurate, but it can be understood in this way). The smoke exhaust pipes in each household's home enter the auxiliary flue, and the upper and lower parts of the auxiliary flue will not be connected. There is another opening between the auxiliary flue and the main flue, but if the smoke exhaust pipe is installed on the main flue, then there is a possibility of the situation you said.

    Advice: Check with the property and they should know about it too.

  2. Anonymous users2024-01-22

    That is the problem of the flue outlet, try to install a draft induction device to the flue outlet to see the effect.

    Or install a damper at the flue mouth for you, open the damper when you use it at home, then open the exhaust air, and close the damper when not in use.

  3. Anonymous users2024-01-21

    How to say it, the flue problem is very annoying, in fact, the flue is not open when decorating, each user has their own flue, but the decoration of the person to open it up, it will be connected with the upstairs and downstairs, which is more difficult to get

Related questions
1 answers2024-03-02

1. Artificial entry method.

If the flue at home is a parallel flue larger than 40 cm, then you can find a professional worker to drill into it to clean it, but the labor intensity of the manual entry method is relatively large. Therefore, it is necessary to pay attention to strengthening ventilation and must also be equipped with low-voltage lighting power supply. >>>More

6 answers2024-03-02

When you cook at home, you go to the 5th floor to observe one. Let's see what's going on. >>>More

5 answers2024-03-02

Consulted the professional manufacturer of the flue, said that the quality of the flue is not good, the assembled flue is made of magnesium oxide and magnesium oxide, so it will regurgitate and then seep water, so it is recommended to find a professional replacement flue, otherwise it will fall down piece by piece after a long time of sticking bricks, and the offense will be endless!

2 answers2024-03-02

How to design a kitchen solitary flue? 1。Be sure to design a place with good air circulation, so that it is convenient for the smoke to flow smoothly! >>>More

1 answers2024-03-02

Let the bricklayer master handle it, and use bricks or other materials to build the wall and plaster the cement. There are main flues and auxiliary flues. Remember to install the flue check valve.