What should I do if the bathroom leaks and I don t want to smash the tiles?

If the leak point is in the floor drain range, it is difficult to solve the problem without knocking the tiles. However, the advantage is that you only need to knock off the tiles within the scope of the floor drain and re-do the waterproofing and then pave it, and you don't need to knock them all.

If it is not just the leakage of the floor drain range, it is necessary to knock off all the floor tiles and redo the waterproofing, because there is no good way to judge where the specific leakage point is.

If so, the leakage point can be determined and the leakage point can be completely excluded from the floor drain range. You can try it by brushing the tiles in the area with a clear waterproof paint. Of course, try to keep the area as dry as possible.

1. If the bathroom is leaking from the waterproof layer, rather than the water from the upper and lower water pipes, it can be repaired without smashing the ground. The maintenance method is very simple, that is, use a new type of penetrating waterproofing agent to waterproof the surface of the bathroom again, so that the water does not enter the ground and flows directly from the waterway.

2. If it is a problem with the upper and lower water pipes, and the water pipes are underground, you need to consider smashing the floor, but it is not necessary to redecorate the bathroom. For example, if the inlet pipe is leaking, you can change the pipe to avoid the leaking pipe. If it is a leak in the sewer pipe, it is also necessary to find the specific location of the leakage, and according to the situation, it is determined that it is partially planed bricks to solve, and it is not necessary to smash them all.

Tile water seepage can be considered without removing brick waterproofing or other waterproofing solutions, such as the following methods.

Bathroom tile water seepage must first understand what causes water seepage, there are several reasons: first, the waterproofing of the bathroom is not in place; The second is that the water pipe in the wall is broken and leaks; There is also in the rainy weather, due to the humid air, resulting in water on the surface of the tile; After that, the tile gaps are not good, and there is water seepage.

If there is a problem with the waterproof layer, the tiles must be removed, the wall must be hit to the waterproof layer, and it is better to see the inner wall, and then scrape the putty again, re-make the waterproof layer for the wall, and then pave the tiles.

Scope of application: Suitable for waterproof layer breakage - this method is the easiest to operate, but the life is shorter. Basically, it takes three or five years to do a new penetration waterproofing.

Scope of application: Suitable for joint waterproofing damage or sewer pipe rupture - go downstairs to look at his ceiling, if the ceiling is like this, prove that the waterproof layer at the joint is broken.

Scope of application: The waterproof layer is damaged due to the deformation of the building - the cracks in the ceiling can be clearly seen from the downstairs (if the wall is leaking, the gaps can also be seen in the wall). After the floor slab is deformed, the original waterproof layer is pulled by external forces, and gaps will be generated.

Bathroom leakage, we must first find out the cause of the bathroom leakage, and then take the corresponding solution. The common causes and solutions of water leaks in the restroom are as follows.

Waterproof layer leakage: The manifestation is that after bathing or using water on the ground, the downstairs leakage is serious, and the downstairs performance may be one or more places. The judgment method is very simple, plug the floor drain, and then release water on the ground, pay attention to the observation of the water leakage downstairs after 40 minutes, if the water leakage downstairs is serious, it is determined that the waterproof layer is leaking.

You can use waterproofing agent, caulk, plastic steel mud can be repaired, and the surface of the bathroom can be waterproofed again, without planing tiles, saving time and cost.

Sewer pipe leakage: manifested around the sewer pipe, there is a serious dripping phenomenon. The way to judge is to drain the floor, the hand basin, fill the water, and repeatedly flush the toilet, and see the aggravation of the water leakage downstairs, it is the leakage of the sewer pipe.

In this case, find a repairer to replace the sewer pipe and try to reduce the bricks as much as possible. Then it also needs to be waterproofed under the ground rework, and there is no need to plane all the bricks. You can use Xiuyixiu's products to do waterproofing for bathroom leak plugging repair.

The above is just a simple self-inspection method, if you want to really deal with the problem of water leakage in the bathroom, it is best to find a professional to deal with it, not only to avoid the hidden dangers that are not found in the self-inspection, but also to find the problem of water leakage in the bathroom in time.