I was assigned a single dormitory in the unit, but the exhaust fan in the kitchen was not plugged an

Go to the 5 gold store, buy a 2-pin plug and a small screwdriver, if the line is not long enough, you can buy a square flower wire [that is, a two-core wire] to connect the length remember to buy electrical tape.

After going home, open the back cover of the exhaust fan, there are generally three lines inside, which are the live wire, the zero line, and the ground wire, of which the two colors are mixed [generally white and green is the ground wire], the ground wire can not be connected, just seal it with adhesive tape, and if the other two lines are long, peel off the outer layer of rubber with scissors respectively, twist the scattered copper wires inside by hand, and wrap them separately with adhesive tape after receiving the flower wires, and wrap them once in the package.

If you don't need to connect the plug directly, then twist the screws on the outside of the plug, and there are two square wiring holes inside [there are two small screws on it that are used to fix the wire] and then loosen the screws on the top [no need to take it out] respectively to glue the two wires into one each, twist the wire head back once, stuff it into each square wiring hole, and twist the screw to fix the wire head.

It should be noted that the length of the rubber sheet for the wire removal should be suitable for the jack, and the copper wire outside the wire hole should not be exposed to the plug to prevent the wire from touching the wire.

Buy a two-phase plug, there is a screw on the plug handle, unscrew it with a cross change cone, it will be two pieces, the outer skin of the wire head drawn out of the exhaust fan is bare 2cm, and screwed to the screws on the two copper sheets of the plug respectively, be sure to tighten it, the two wires should not have a trace of overlap, and finally tighten the fixed screw on the alignment of the socket handle.

This is too simple, needless to say, buy a plug, turn it on, and then turn on the exhaust fan, there are three wires inside, only use L and N two, the ground wire can not be connected, the ground wire is generally white and green cross, connect it to the plug, pay attention not to touch the two wires, to prevent short circuit, to plug the wire into the plug copper wire do not hug the outside, to prevent electric shock.

Open the back cover of the exhaust fan, there are two binding posts inside, and then connect the two wires on the plug to the binding posts.