-
Anonymous users2024-01-231. On-site inspection.
Sports wood floor maintenance staff, or stadium staff, when they find that the sports wood floor is soaked in water after work, don't panic first, be calm. The first time to inspect the soaking site, eliminate potential safety hazards, such as whether there are wires, electrical appliances, flammable and explosive materials on the soaking floor.
Then according to the degree of water immersion of the sports wood floor, a solution is formulated.
>2. Soak in water lightly.
If the sports wood floor is lightly soaked, the lightly soaked and damp floor can be wiped dry and ventilated. If necessary, disassemble the sports wood floor to observe whether there is water on the ground and observe whether the floor is obviously deformed. If so, it needs to be removed and dried, and reinstalled.
3. Heavy soaking.
The sports floor of the body cracked bridge wood floor is seriously damp or soaked in water for 30 minutes, and the sports floor will be deformed, expanded, and lost its luster. Such sports wood flooring is basically scrapped and should be replaced, and attention should be paid to removing the moisture under the floor and drying it.
4. Precautions.
After the sports wood floor is soaked in water, it is important to pay attention to the fact that it cannot be blown by hair dryer, exposed to sunlight, or dried, which will accelerate the serious deformation and damage to the surface of the sports wood floor of the basketball hall.
-
Anonymous users2024-01-22It is okay if it is pressed with a heavy object and dried in the shade.
Soaking in water on a solid wood floor is really a headache! Drain the visible water and spread it on the floor with a dry cloth! Keep the room warm and dry at the same time! >>>More
Regardless of whether the joints of the solid wood floor or laminate solid wood floor bulge after soaking in water, there is no other remedy except to replace it (which can be replaced as a single piece). >>>More
Such second-hand flooring is just very troublesome when finishing, there is no problem with use, and it does not affect the service life, but the effect of painting itself is not as good as the process on the assembly line.
There are two possibilities: First, the floor paint is worn out during sanding (the paint on the original floor is not wear-resistant--- don't believe it, I've helped people clean up the mess a few times! This can only be solved by sanding and repainting. >>>More
It is unqualified for drying, which makes the adhesion of paint weak. Then when it dries and shrinks, the paint is pulled and pressed and the paint peels off.