-
Anonymous users2024-01-23If the bathroom area is relatively large, it is recommended to install floor heating, if the area is relatively small, do not install a bath bomb or heater.
It is recommended to install underfloor heating separately from the underfloor heating in other areas of the home, and install electric underfloor heating separately.
-
Anonymous users2024-01-22There are many ways to heat the bathroom, the traditional one is the bath bomb, and later there are bath bombs with heaters, and customers who have installed heating can install bathroom towel rails, which are auxiliary heating and will not be cold.
But to be thoroughly warm and comfortable, it is better to learn from Shangri-La, learn from Tomson, and use Nexans heating cable, which can be installed to 250 300W per square meter, and the temperature reaches more than 25 degrees.
In the kitchen and bathroom, it is recommended to make a suspended ceiling, because the ceiling of the kitchen and bathroom usually has a lot of pipelines, and it is more beautiful to cover the pipes to make a suspended ceiling, and it is convenient to clean and clean. As for whether the living room bedroom and other spaces need to do the ceiling, it depends on the specific situation analysis, if the floor height of the home is higher, you can appropriately do some ceiling modeling to set off the overall decoration, if the floor height is lower to do the ceiling, it will be more depressing, you can choose the gypsum line to do alternative decoration.
Nowadays, the house is generally about meters, and the floor height is not very high, so there is no need for a suspended ceiling.
Hello! It is recommended that you use suspended ceilings.
Installing floor heating is the embodiment of the improvement of the quality of life, usually the bathroom needs to lay floor heating, there will be no coolness when barefoot, generally the water separator of floor heating will be set in the cabinet below the kitchen sink or in the bathroom under the washstand, but the bathroom waterproof should be in place, the floor heating coil laying should be pressed to 6kg, and the pressure should be maintained at 4kg until delivery, and the protective layer should be in place after the floor heating pipe is laid, and the water and electricity laying of the bathroom should be carried out in accordance with the construction standards and specifications, and the protective layer should be poured for 24 hours after the water storage test, There is no leakage, and the wall and floor tiles can be paved. Bathroom waterproofing is usually 30 cm in the dry area, wet area and public walls with other rooms.
It is better to do waterproofing for the following reasons: >>>More