-
Anonymous users2024-01-23If you can flush it with a basin, it proves that the water should be fine.
I think there are two possibilities.
1.The problem of water pressure, this problem cannot be solved by individuals, there is no good way 2It's the problem of the toilet itself, so it's recommended that you choose to change the float in the tank to take a look.
I have encountered such a situation, some of the floats in the tank can be adjusted, first see if you can adjust, if not, change to adjustable.
-
Anonymous users2024-01-22If the pumping force is reduced, it is a little blocked inside or the sewer pipe.
-
Anonymous users2024-01-21If it can be repaired, replace the flange below with another one, and then adjust the water volume of the tank.
You can go to kitchen and bathroom electrical accessories to buy it, it's not expensive.
This is obviously not installed by the workers, and it must have fallen off without tightening the expansion screw at the top.
1. The rubber pad of the drain is broken;
2. The float valve is broken or mediated too high, higher than the overflow port, resulting in continuous water ingress, and then water flows out of the overflow port, which is more likely; >>>More
According to Article 39 (3) of the Labor Contract Law and Article 16 of the Interim Provisions on Payment of Wages of the Ministry of Labor, if an employee suffers major property losses due to serious dereliction of duty and causes quality problems, the employer may terminate the contract and require the employee to appropriately compensate for part of the losses. Therefore, the contract was terminated without severance payment. >>>More
The floor drain anti-overflow test experiment tells you how to choose a suitable anti-overflow floor drain.