How to install the toilet in the bathroom

First of all, unpack the toilet, check the integrity of the toilet, and install the water inlet pipe.

Install the water inlet triangle valve, level the sewage pipe, and clean the ground.

Install the sealing ring between the toilet outlet and the ground outfall. (Note: Be especially careful when installing the sealing ring, whether there will be water leakage after installation, and the installation of the sealing ring is important).

When installing the toilet, it is necessary to align the position of the toilet outlet and the sealing ring, and the general toilet outlet should fall into the sealing ring, and do not press on the edge of the sealing ring, otherwise it will definitely leak.

After installing the toilet, you can lay glass glue around the bottom and connect the water inlet pipe to test the water. The toilet is installed.

Precautions: The ground sewage pipe must be flat on the ground, and it is best not to sink under the porcelain plate, so that there will be no water seeping downstairs.

When playing glass glue, be sure to keep the place to be played dry and clean.

Before installing the toilet, the sewage pipeline should be comprehensively inspected to see if there is mud, sand, waste paper and other debris in the pipeline, and at the same time check whether the ground of the toilet installation position is horizontal.

Determine the center of the sewage pipe and draw a cross centerline.

Flip the toilet, center it on the toilet drain, and draw a cross center line, which should extend to the bottom of the toilet around the feet.

If there is a screw installation position at the bottom foot of the toilet, it is recommended not to use it, one is to destroy the waterproof layer, and the other is to fear that it will crack the toilet if it is tight.

Install a special sealing ring on the toilet drain.

Align the cross line on the toilet with the cross line of the ground sewage outlet, install the toilet, and press the sealing ring tightly, and then put a circle of glass glue around the bottom of the toilet, and the toilet installation should be kept at the front and back left and right level.

Install or debug the tank fittings. Check the water pipes first, drain the water for 3 5 minutes to rinse the pipes to ensure the cleanliness of the water pipes; Then install the angle valve and the connecting hose, then connect the hose with the installed water tank accessories inlet valve and press the water source, check whether the water inlet and sealing of the inlet valve are normal, check whether the installation position of the drain valve is flexible, whether there is jamming and leakage, and check whether there is leakage and install the inlet valve filtration device.

After the toilet is installed, it should wait until the glass glue has cured before it can be used with water, and the curing time is generally 24 hours.

Precautions: 1) When installing the toilet, please do not pour cement mortar into the cavity in front of the toilet or other cavities, so as not to crack the toilet feet due to cement condensation and expansion.

2) When using the toilet, please do not flush newsprint, diaper pads, toilet napkins and other easily clogged items into the toilet.

3) The toilet should not be used in a sub-zero temperature Celsius water environment, otherwise the water will freeze and expand and crush the ceramic.

4) To prevent breakage and water leakage, please do not hit the ceramic with hard objects.

5) In order to keep the surface of the product clean, please clean it with a nylon brush and soapy water or neutral detergent, and it is strictly forbidden to clean it with a steel brush and a strong organic solution, so as not to damage the glaze of the product and erode the pipeline.

Determine the distance between the water and the wall, i.e. the hole spacing. Buckle the glued toilet flange to the drain hole, install the toilet, apply glass glue, and adjust the flush.

Hehe, the downstairs are all the correct solutions.

Whoever you buy, it's free to install!