-
Anonymous users2024-01-23Open the lid of the water tank and press the button directly in the bucket to see what is going on. If the water comes out, it's just that the button under the lid isn't long enough – the length needs to be adjusted!
-
Anonymous users2024-01-22The water plug is not open and there is a problem with the connection.
-
Anonymous users2024-01-211. Open the back cover to see.
2. Is there a problem with the leather bowl cable?
3. Whether there is a fault in the lever contact.
4. Try it manually.
-
Anonymous users2024-01-201. a filter.
Many toilet refillers have a filter inside, and the filter will be clogged with too much limescale after being used for a long time, so that tap water cannot come in. Just remove the strainer and clean it.
2. a piston. Open the lid of the toilet bowl and observe that there is no water on the tank. Whether the piston can be plugged. If it can't be plugged, it will leak, the water tank is not satisfied, and the switch can't reach, so it won't be watered.
3. Float. Open the toilet lid to check whether the float sinks to the bottom when the water tank is empty, if it is still above when there is no water, it means that the float is broken, and it cannot sink and the upper water outlet is always closed, so there is no water.
4. a water inlet valve.
Check if the toilet lid will reach the inlet valve, and if so, adjust the inlet valve. Then look at whether the float of the inlet valve will move up and down freely, because if it is stuck, the water will not be able to enter.
Do other water pipes come out of the water? If you don't get out of the water, you must be in arrears.
There are several kinds of <> drain valves, and the picture is for reference. If there is water in the water tank and cannot be pressed, it is a drain valve problem; If the water inlet is normal, the water tank cannot hold water, which is also a drain valve problem; If you can't get water, it may be a problem with the water inlet valve. FYI. (Image quoted from image).
It is possible that the water pipe leading to the bathroom is broken, or blocked.
The old toilet tank does not come out of the water is not the fault of the float, the float only plays the function of controlling the water inlet of the water tank and terminating the water intake, you said that the water does not come out when you press the button, and the water comes out only when you pick up the cover, which is the reason why the connection cable between the button and the drain of the toilet tank has some length. >>>More
Generally, the toilet does not drain because the outlet at the bottom is not aligned with the drain, and the screws at the bottom of the toilet bowl are broken, which will cause the toilet to drain through, or the toilet has been used for a long time, and it will scale on the inner wall, and in serious cases, it will block the vent of the toilet bowl and cause the toilet to drain slowly, and it is also possible that the cement or tile fragments fall into it during decoration or will affect the drainage.