What should I do if the kitchen sewer pipe is scalded by boiling water, and what can I do to get it

Updated on Kitchen 2024-03-21
1 answers
  1. Anonymous users2024-01-23

    Use a suitable plastic or metal pipe that can be placed on the inside, and then use a hair dryer to heat the outer wall of the pipe while slowly trimming the inside with a thin pipe.

Related questions
3 answers2024-03-21

It won't be burned, if it is burned, the downstairs will be found a long time ago, but in the future, you don't want to pour such hot water, just add soapy water at 50 to 60 degrees.

9 answers2024-03-21

One of the best tips on what to do if the kitchen sewer is blocked: Find a wire with a diameter of millimeters, 3-4 meters long, fold it in half from the middle, and then twist it into a strand, and then bend the two heads in different directions on the side of the single end, and then stretch this end into the sewer pipe, grab the other end, and twist it in one direction while going inside, if you encounter resistance, you can't stretch it in, just drag it out, don't twist it at this time, drag it directly, some sundries can be hooked out, and you can basically dredge it after repeating it several times, if your wire hook can't get something, is unblocked, then the problem may not be your home, it may be the downstairs pipe blocked. What to do if the kitchen drain is blockedTip 2: >>>More

1 answers2024-03-21

1. First of all, we can try some simple methods. For example, for the greasy blockage of the sewer pipe, you can first pour a pot of boiling water into the sewer pipe to try, and then dredge it again The effect may be better, after pouring the water, you can use a hook or other tools to reach into the drain pipe to remove the clogged dirt inside. If you live on the first floor, you should first check the exterior sewer for any accumulated leaves and mud that are clogging the drain. >>>More

3 answers2024-03-21

If the kitchen sewer pipe is blocked, it can't be passed with a dredger, because the oil is stuck to the inner wall of the sewer pipe, under normal circumstances, go to the market to buy some alkaline substances that dissolve the grease and put them in the sewer pipe and flush them with hot water.

1 answers2024-03-21

If it is exposed, find the leakage point and cut off both ends to buy two outside directly, a bottle of glue, if it is a hard hole, you can also use AB glue and yarn to make up directly, but it requires clean and dry construction, a little troublesome, both methods only use a few dollars!