-
Anonymous users2024-01-23Blowing down the tomb and collecting the Xi collection system to seek the kind of gluttony The waste of water is a very troublesome problem.
When there is a failure of non-stop water ingress, the following aspects are mainly checked:
One. If the float of the pontoon cargo float of the inlet valve is stuck, you can pull the float up and down with your hand, and it can move up and down smoothly under normal circumstances.
Two. There may be foreign matter inside the inlet valve, resulting in the needle valve pressure chamber at the top of the inlet valve can not be formed and can not stop the water, in such a situation, for the general user, there is great difficulty in repairing alone, it is best to ask a professional to repair or buy a replacement. When purchasing the water inlet valve, be sure to measure the height of the water tank in advance, so as not to cause the water inlet valve to be installed due to the fact that the water tank is too low, generally speaking, the adaptability of the domestic split (water tank and toilet bowl separated) toilet is better, and most of the water inlet valves can be used, and the conjoined (water tank and toilet bowl are integrally formed) may have a water tank too low due to process reasons, please be careful.
For areas with poor water quality, when buying an inlet valve, especially the more common needle valve, it is best to equip it with a filter to filter impurities, or use an old-fashioned simple inlet valve (the one with a large float) Regular cleaning of the inlet valve can also reduce the occurrence of more than water: 1 Remove the inlet pipe of the water tank from the left side of the bottom of the toilet, and then remove the plastic nut at the bottom of the inlet valve. Then you can take the inlet valve out of the tank.
2. Remove the water supply pipe of the water inlet valve (generally at the top, a plastic hose, the overflow pipe connected to the drainage valve), pick up the plastic cover, loosen the water drifting connecting rod, and then take it up and down and twist it in the opposite direction.
If you look at the inner core of the toilet, it must be inflexible or leaky due to aging.
The toilet has been on the water solution:
1. You can check whether the flush switch is restored to its original state, because the flush switch in some toilets is easy to wear out after being used for a long time, or it is stuck, so it cannot be restored. Typically, the switch can be reset by repeating it a few times. >>>More
The toilet inlet valve is not only water, but the mud and sand in the pipe may be stuck in the sealing ring, you can use your hand to move the float valve up and down to let the water wash away the mud and sand, and you can also adjust the float lower, which can lower the water level.
The float in the tank drives the water inlet valve of the water tank, when the float floats up and the valve is not closed, and the water continues to enter, it must be a problem with the valve, so you have to check the valve, whether the link between the float and the valve is loose, or the valve is broken, and then it is easy to deal with. >>>More
The toilet inlet valve is generally not easy to break, and sometimes the water level of the water tank is too high, you can lower the float valve by a point.