What to do if the water on the toilet is broken

If the toilet is always on the water, maybe it is a problem with the water tank, you can check whether the material or parts of the water tank will be too old, because some small parts are relatively unused, and it will not take long for the phenomenon of damage, if it is used for a long time, there will be problems, then it is a phenomenon of natural wear and tear, as long as it is replaced, the phenomenon of leakage on the toilet does not stop and cannot be eliminated, it may be because of the sewer pipe, because the function of the sewer pipe is used to connect the toilet tank, It is also possible for a major conveyor pipe to have this problem.

In daily life, the toilet is likely to have problems after being used for a long time, which is a common phenomenon, in fact, many people do not know how to repair the toilet when it is broken, and feel very annoyed.

The newly installed ones are generally not broken, you check whether there is a tap water filter at the upper water pipe of the toilet, and you can open it for cleaning.

There should be debris blocking the water space, turn it off, turn off the toilet hose here water inlet switch, rotate the water supply rod in the water tank counterclockwise, take it at the bottom, take it out, open the water inlet valve, clean the water inlet, and brush it with a brush at the same time to make sure that there is no hard object on this side of the mouth, and finally install it clockwise.

1. You only need to close the water inlet valve, open the upper cover of the water tank, remove the blue plastic soft cover on the water feeder (the round pipe and other devices), and then remove the small bolt at the other end of the float, remove the small black round rubber gasket, turn it over and install it again, and finally install the parts as they are, which will generally solve the problem;

Second, the toilet water inlet device can not be closed normally, it may also be that the float valve of the water tank is damaged, because it can not automatically float and close, the water does not stop working, and it is always in a state of non-stop water, you can open the toilet cover, observe the flexible state of the float and other accessories, whether there is any accessory friction obstruction interference, rule out these possibilities or not, it is recommended to replace the new float valve device.