-
Find out if the faucet on the sink is broken. Detecting this is very simple, you unscrew the bolts of the hot and cold water pipes connected under the wash basin (turn off the hot and cold water valves beforehand), check whether it is a pipe problem one by one, if both come out of the water, and the water pressure is sufficient, then it proves that the faucet on the wash basin is broken.
-
To deal with the faucet on the wash basin, you first have to determine if the tap on the wash basin is broken. Detecting this is very simple, you unscrew the bolts of the hot and cold water pipes connected under the wash basin (turn off the hot and cold water valves beforehand), check whether it is a pipe problem one by one, if both come out of the water, and the water pressure is sufficient, then it proves that the faucet on the wash basin is broken. Removing the faucet on the wash basin needs to be carried out from the bottom of the wash basin, there is a bolt at the junction of the faucet and the wash basin, it is easy to remove it with a wrench, and it is OK to replace it with another one after removing it (Note:
The bolt is under the basin, and the person either drills under it to operate it or flips the basin over to operate).
-
If the inner wire is broken, there will be water leakage, and no water leakage is good.
-
In general, when the light hits the faucet, there is no problem with the inner wire.
-
Observe, if it doesn't leak, it's fine, and the leak will be repaired immediately!
-
No, it's not that easy to break, and if it does, it's a faucet.
-
As long as there is no water leakage, it should be fine, but observe whether there is water seepage frequently, and deal with it in time.
-
Pay a little attention when using it, be careful, and be careful.
The water leakage is because the ceramic plate of the copper spool inside has reached the end of its life, and it is more difficult to take it out if there is cracking or leakage, and the screws are rusty and slippery. >>>More
Most of the faucets are bronze products, the surface is electroplated, and the gold ring is still lightly touched, which will not wear out its surface, rest assured, it's okay.
Up to 75, 85 in case of temperature control failure
Is it caused by sand in the filter of the cold faucet?
1. Whether the tap water pressure of the user's home has become smaller than before >>>More