-
Anonymous users2024-01-23Poor contact means that the wiring joints in your home are not firm, and the connection is loose.
-
Anonymous users2024-01-22It's better not to do this yourself. Buy a night light separately. Worthless. Otherwise, it will not be good to be electrocuted.
-
Anonymous users2024-01-21It means that poor contact is often used in circuits, which means that the line can not conduct current well and cannot constitute a complete electrical circuit, so it leads to no power or intermittent power-on, which is easy to cause heating, so don't use it.
-
Anonymous users2024-01-20There are many reasons for this, which may be caused by poor electrogenic contact, or poor contact of electronic components.
-
Anonymous users2024-01-19According to the conditions you give, it should be caused by the false connection of the line. The solution is as follows: 1. Slowly turn the lamp tube to observe whether the fluorescent lamp is on.
2. If it doesn't light up, continue to rotate the starter. 3. If it still does not light up, use an electric pen to measure whether the input and output of the ballast have electricity. Check whether the wiring inside the lamp is broken.
4. If the above does not solve the problem, it is recommended to replace the fluorescent lamp. 5. If the problem still can't be solved, this time the person will be replaced.
1. The starting capacitor is attenuated. 2. The governor is aging and the resistance becomes larger. 3. The voltage at home is too low.
It's definitely not good, the electric fan blowing too much will make you lose your energy, you can drink a little more water, add a little less salt water to solve it.
Hello, in fact, the ceiling electric fan consumes a little more power than the floor fan. However, it still doesn't consume much power.
The general specification stipulates that, but in our actual use, the multi-strand copper core wire used is good. The governor has a coil type, an electronic speed regulation, and it is installed according to the wiring of the manual, so what else? The governor of the coil is relatively large and heavy, generally not used much now, really need to use this, only to make a wooden base, nail the base to the wall, and then fix the governor on the base with self-tapping wire wiring, electronic speed regulation is generally matched with the 86 boxes we often use, and the screws that come with the wire are installed on the switch box. >>>More
You don't need to disassemble it, but you can generate electricity by leaving the capacitor empty!