Ask how to install the corner line of the PS ceiling

In fact, it can be installed according to the corner line of the Marco Borough integrated ceiling, or it can be easily installed by following the following 7 steps:

1. The corner lines required on the four sides of the room are cut according to the actual size of the wall.

2. Paste the corner line required by the wall below the horizontal line, align the horizontal line on the corner line, and mark the hole in the edge line, and the hole spacing is 10 15. 3. Hit with an electric hammer? 4 holes, punching must be accurate to the center point of the crossed line, the depth of the hole is about 30.

4. Punch the expansion pipe into the hole, and the expansion pipe shall not exceed the installation wall.

5. According to the angle of the corner, cut the two ends of each corner line into half of the corner, the standard wall angle is 90 °, that is, the two ends of the corner line are cut into 45 °, and fasten the trimming corner line with the self-tapping screws of 4 20, pay attention to the diagonal smoothness and gap of the corner line.

6. If the corner line must be installed above the tile, the wall should be installed on the front wall of the installation corner line, the thickness of the wood bar is the same thickness as the tile, the surface of the wood bar is flush with the surface of the tile, and the installation method is the same as the installation of the corner line.

7. In addition, the corner line installed on the surface of the tile can also be pasted on the tile with strong glue such as 502 glue, so that all fixed wooden strips can be saved.