Is it good to use Aopu s new built in air conditioning fan in the bathroom?

Updated on Bathroom 2024-02-25
1 answers
  1. Anonymous users2024-01-23

    Is it a broken resistor, capacitor, etc.? This one doesn't seem to have an overheating protector.

    Is the bath bomb you installed a special power supply (only the bath bomb is not connected to other loads on this route)? You are looking to see if there is a voltage in the inlet position of the switch that controls the bath bomb:

    1): There is a voltage that may be broken by the switch or the light (including whether the connection line between the switch and the light has been bitten by mice).

    2): No voltage is the problem before your incoming line.

Related questions
How to change the integrated recessed light in the bathroom?
3 answers2024-02-25

1. Cut off the power supply, be sure to pay attention to safety; >>>More

How to disassemble and assemble the embedded lamp ballast in the bathroom if it is broken
1 answers2024-02-25

Just buy one, and the lamps and lanterns are all sold. If you are under warranty, call customer service.

How to dismantle the built-in ceiling light in the bathroom?
4 answers2024-02-25

Rotate the four heating bulbs counterclockwise to remove them, and then you can see the spring hooks next to them. Pull the spring hook down to remove the mask. Then you can see the screws on the bath bomb chassis, and you can remove it. >>>More

Is the bathroom bathtub overall good or a built-in bathtub
3 answers2024-02-25

However, the acrylic bathtub has a good cost performance, but the weight of the cast iron bathtub is very large, the noise is small, it is not suitable for handling and installation, and the price on the market is also very expensive, easy to age, read the following answer I believe you should have the answer! Hopefully, my answer will help you, easy to handle and install. However, the disadvantage of acrylic bathtubs is that they are easy to fade and are easy to be scratched. >>>More

How to replace the recessed light in the bathroom if it is broken
5 answers2024-02-25

1. Disassembly of ceiling lamp:

First of all, remove the lampshade, the lampshade is the simplest, there should be a small arrow on the side of the mask, you press it to open, it is a live clip, you will see the wiring after removing the lampshade, remove the zero line of the live wire with a screwdriver, and finally remove the chassis directly. There is also a kind of embedded ceiling lamp that is fixed with a live clip, and there is no screw, so just pull it down directly, and the clip on the chassis is just stuck on the ceiling, and you can take it off. >>>More