-
Anonymous users2024-01-23The pipeline is blocked, and the water flow cannot meet the basic requirements of the water heater.
The hot water pipeline on this side of the bathroom is blocked, resulting in a large back pressure over the water, and the water-gas linkage device of the water heater will think that the hot water faucet has been closed and close the gas channel, and there is no gas, of course, it cannot catch fire.
It is recommended to clean and descale immediately, and you can buy a set online.
The gas water heater does not need to remove the scaler, use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, the operation is simple and convenient, and it can be cleaned regularly after use, when this problem can be avoided again.
-
Anonymous users2024-01-22The temperature of the heat exchange surface of the water heater is very high, and there will be scale when the water flows through, and after a long time, there will be a lot of scale attached to the surface of the heat exchanger, which will accumulate over time, causing the hot water pipeline to be blocked, which will cause the hot water output to become smaller (the phenomenon of small water pressure), the hot water output time will become longer, and it is not good to ignite and other problems.
Whether it is water-controlled or constant temperature, the premise of the normal operation of the gas water heater is that the water flow is normal, and the water flow in the water heater must meet the conditions, but the water heater is always generating scale in the process of use, and over time, the hot water pipeline that is used more will be blocked first, resulting in a large back pressure of the water flow, and to a certain extent, the water-gas linkage valve will automatically close the gas channel.
It is recommended to clean and descale immediately, and you can buy a set online.
The gas water heater does not need to remove the scaler, use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, the operation is simple and convenient, and the problem will be solved after descaling.
-
Anonymous users2024-01-21The problem of water pressure.
The gas water heater is automatically opened with water pressure to open the starting valve. However, when the water pressure is low, the starting valve cannot be opened, and the gas cannot be ignited.
Your water heater is installed near the kitchen, and the water pressure in the kitchen is higher than in the bathroom, so the kitchen works. The pipes in your bathroom must be long, and the water pressure is not enough. So it can't start.
You can get a plumber to change the plumbing for you, or install a small booster pump in the bathroom
This problem is estimated to be that there is a foreign object blocked in the faucet or water pipe in your kitchen, and the water pressure is not big enough to ignite the fire, you can turn on the water in the bathroom and kitchen at the same time to see if the water flow is the same, if the water flow is the same, or not, then a professional maintenance master should come to see if the water heater is broken.
The reasons may be as follows: 1. Battery problem - if you use a battery, you should first see if the battery is too old, and the water heater will not catch fire if the voltage is not enough. >>>More
Clean the pipes with vinegar, preferably for four or five hours in pipes that do not produce hot water, to ensure that it is effective.
According to the regulations, gas water heaters can only be installed in the kitchen to be safe, so it is very convenient to wash vegetables in winter.
You don't know what to say just by providing this valve handle. But let me tell you, to convert a solar water heater into a gas water heater, you must first close the inlet and outlet valves of the solar water heater. Then open the gas water heater inlet valve and open it.