The toilet socket works on the whole building tripped

Updated on Bathroom 2024-02-27
4 answers
  1. Anonymous users2024-01-23

    Indicates that there is a leakage of electricity in the toilet socket.

  2. Anonymous users2024-01-22

    Let's see if the neutral wire and the ground wire are reversed.

  3. Anonymous users2024-01-21

    If there is a leakage and the pipes inside are broken, all the engineering lines should be replaced before the special repair, and each line pipe should be re-pumped out with an air gun.

  4. Anonymous users2024-01-20

    If there is a problem with the wiring, let the electrician change it, and it should be threaded.

Related questions
What should I do if the bathroom air switch is pushed on and it trips
6 answers2024-02-27

The air switch is a very important electrical appliance in the low-voltage distribution network and the power drive system, which integrates control and a variety of protection functions. In addition to being able to complete contact and break circuits, it can also protect circuits or electrical equipment from short circuits, serious overloads and undervoltages, and can also be used to start motors infrequently. >>>More

What is the original purpose of tripping when the air fan in the bathroom of my unit is powered on
3 answers2024-02-27

The ventilation fan motor is tripped, and the ventilation fan needs to be replaced.

The bathroom on the second floor uses water, and the basement bathroom will not squat in the pit, on
5 answers2024-02-27

It is that the main pipeline is not smooth, the upstairs water consumption is large, the impact is strong, and it is too late to discharge to the seepage well, it will be piled up in the pipe, and the water surface of the squatting pit should also rise, but the sewer pipe of the wash basin is thin, and the water surface rises more, and it is backwater. Buy a lot of pipe melter, preferably the gel-like one, flush it down the drain with boiling water, soak it for a while and then come back twice, it should be fine.

Toilet socket height
10 answers2024-02-27

Toilet socket installation height:

1. The installation height standard of the washing machine socket is about off the ground. >>>More

What's going on with the old tripping when the bathroom is empty
4 answers2024-02-27

The air switch tripping is generally caused by the load exceeding the rated current of the air switch, it is recommended to check whether the load circuit is working normally, if it is working normally, it is necessary to replace the air switch with a larger rated current, and at the same time, it is necessary to consider whether the wire diameter of the wire can meet the use requirements.