-
Anonymous users2024-01-23Restaurant chandelier installation steps:
1. Preparation for installing the drill bit
When preparing the drill bit for the installation of the chandelier.
Be sure to choose a suitable electric drill, because the hole in the ceiling is generally 6mm, if the size of the electric drill is not suitable, it is not possible to install the chandelier.
2. Drilling: After the hole position is determined, you can drill the hole, and you must pay attention to the depth of the hole when drilling, at most not more than 6mm.
3. Upper expansion screw: Race the expansion screw into the hole and knock it in with a hammer to ensure its fastening and ensure that the follow-up chandelier is in use.
There will be no drooping.
4. Fix the hanging plate: completely embed the expansion screw into the wall, and then fix the hanging plate, when carrying out this step, the hanging plate must be installed firmly, and the wood screws should not be offset.
5. Fix the ceiling tray and lamp body
Connect the hanging plate and the ceiling tray with screws, and after the screws are screwed, the ceiling plate can be fixed, and this step still needs to fix the ceiling plate firmly.
Precautions for installation of restaurant chandeliers:
When installing a three-headed chandelier, the height from the ground should be determined according to the roof, the height of the dining table and the environment in the dining room.
Generally, it is advisable to be about the ground away.
The installation of the three-headed chandelier should be pre-embedded in the structural layer of iron or wood bricks, and leave enough gaps for adjustment, but also set up a transition connector on the iron and wood bricks.
The installation of the three-headed chandelier should pay attention to its location and the relationship between the length and shortness, if the installation of the chandelier will be more convenient and convenient when installing the ceiling.
In addition, it should be noted that the rod should be made of a certain length of thread, and the light box is suspended under the boom and sling.
In this way, it depends on the style of your entire renovation, as well as your budget... Anyway, it's up to you to see your own personal hobbies, if you think it's just pictures and no actual senses. It is recommended that you go to participate in the activities of Qijia Group Buying Network, on-site activities. >>>More
If there is no suction cup, you can use a hook instead, or a ceiling installation, and the installation height of the commonly used dining room chandelier can be used with a free device, and the hanging height of the chandelier is determined according to the height of the room, the height of the dining table, and the size of the dining room. The overhanging wire of most chandeliers is fixed, and the length can only be adjusted before installation, and generally the chandelier should be about 55 60 cm away from the dining table. Its lowest point should be no less than a meter above the ground, and such a height will neither affect the illumination nor collide. >>>More
The design of the ceiling is also diverse, and different materials and design types will bring different life feelings to the residents. Whether simple or complex, the design is created for a warm and quality life. The living room ceiling on the market is beautiful, beautiful and atmospheric, so the decorative effect in the living room is also different, then. >>>More
Make sure that the amount of water leakage is large, and if there is a pre-buried line pipe in the property, a large amount of water will sometimes accumulate in it. >>>More
Chandelier is a lamp hanging down, whether the chandelier is hung with wires or iron supports, it can not be hung too low, otherwise it will obstruct people's normal vision and make people feel dazzling. Tools Raw material chandelier installation steps Method? Construction Materials: >>>More