-
If it is water seepage, the water meter will not be able to see that it is spinning at all.
-
There is also this possibility, the water meter is not so sensitive, when the pipe fittings leak, because the leakage is not very large, the water meter can not perceive, and it will not turn, but the leakage does occur, and the wall will be soaked over time. It is possible to do a hydrostatic test and chisel it open with pressure to view.
-
It should be a leaking water pipe, but it's just very small.
-
If the table is missing in front of the table, it will not be turned, and it will be turned after the table.
-
The balcony leaks, the water meter does not turn, the most likely is that the water pipe interface at the balcony may be damaged, there is leakage, it is not the water pipe breakage, just find a professional master to repair it.
-
Hello! This should be water seepage at the water pipe joint, and it may be necessary to open the wall ...... early if it needs to be repaired
-
It depends on whether there is a sewer on the balcony, and whether there are residents above your house, maybe their house is leaking, or the roof is leaking, it is not too serious, you can slowly find the reason.
Since you can't change it, forget it! Just look at the habit!
The first suspicion is tap water, because it doesn't leak after you close the main valve. It is recommended to look at the water pipes, are there any hidden pipes?
Workaround:
1 The pump tank has been filled with water, but the water is still rising until it overflows. >>>More
It's better to use that special toilet cleaner, and then brush hard. I hope the landlord will take my suggestion, thank you.
First of all, the crack is scratched, the interface agent is painted, and the plaster is sewn to make the joint, and after drying, put on the bandage, and so on, after drying, scrape the putty, wait for the dry, scrape the putty for the second time, wait for the putty to dry thoroughly, check, refill the putty, and scrape the putty again, this time is the key time, it must be smooth, not too thick, wait for the putty to dry and polish it flat, and finish it all over the paint, and wait for it to dry, and then repair the putty, polish, and finish the paint twice, and after drying, paint the third coating.