-
Anonymous users2024-01-23First unplug all the electrical appliances in the bathroom, and then go to close, if it is a leakage protector first reset in the closing (there is a small black square on the leakage protection plane, press it to reset), and then plug in the electrical plug after closing, which plug is plugged into the power off again is which electrical appliances have a problem, if the leakage is reset or can not close the switch, it means that the line is faulty, you can only find maintenance personnel, try it
-
Anonymous users2024-01-22Check whether the line is short-circuited or the load is too large, remove the empty load line and try again, if it doesn't work, the empty open is broken, just change it.
There is a leakage or the switch is broken, and there is a black thing in the leakage switch that needs to be pressed in to be connected.
If there is no falling plate, it will be made to drain the same layer without falling plate. Toilet drainage is roughly divided into heterogeneous drainage and same-layer drainage. At present, the drainage of the same layer is divided into the drainage of the same layer, the micro falling plate, and the non-descending plate. >>>More
These are the most likely to have leakage, it should be leakage protection, see if the leakage protection button jumps out.
It's completely OK, the power of the lamp is very small, of course, the normal cable, the light wire and the socket are lined up, I don't know how you can be like this.
You can add a plug-in board at any time.
However, the plug board is easy to get into the water without a shield. >>>More