-
Anonymous users2024-01-23Gas water heaters are water-controlled and have a minimum water flow requirement, which is not met, and the water heater cannot be used because it cannot release gas and turn on the igniter.
It is recommended to check the water output of the hot water faucet, if it is small, it may be a problem caused by insufficient water flow.
The cold water is normal, the hot water output is small, we should consider why the original hot water is large, and now the hot water is small, the reason is that the scale deposit is more original, the problem of blocking the pipeline, the water flow rate does not meet the conditions, and the water heater can not be ignited.
There are many reasons why gas water heaters are not good for ignition, and any component damage of water, gas, and electricity will cause the water heater to fail to ignite. In fact, many times the reason why the fire cannot be ignited is because the hot water pipeline is blocked due to the scaling of the waterway, resulting in a large back pressure of the waterway flow, which is large to a certain extent, and the water heater water-gas linkage device will think that the hot water faucet has been closed and the gas channel is closed, there is no gas, of course, it can't catch fire, if the hot water faucet is fully opened in the near future, the hot water pressure is smaller, and the possibility is greater. Now that the igniter is working properly, it is even more certain.
It is recommended to clean and descale immediately, you can buy a set of gas water heater without removing the scale device online, use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, the operation is simple and convenient, and it can be cleaned regularly after use, when this problem can be avoided again.
-
Anonymous users2024-01-22It is recommended that you have a technician come to your home to check on the situation.
Your home may be too long hot water pipes, after the water heater starts, you have to drain the original cold water in the hot water pipe before the hot water can come out, you just wait patiently for about ten minutes, as long as the water heater fire is burning, the hot water will definitely come out.
Gas kitchen water heater.
This kind of kitchen water heater is the choice of most family kitchens, it has the absolute advantages of high thermal efficiency, fast heating speed, and very stable temperature control. It can be used by multiple people continuously, and this water heater has a large number of regular consumers. Especially in winter, it has the fastest hot water, which has become its biggest advantage, the temperature is constant, and the cost is cheap. >>>More
Small kitchen treasure, about one to two liters, large ones are also available, not expensive, hot water is fast, ready to use.
It may be that your shower room is far away from the water heater in the kitchen, and it takes several minutes for the shower faucet to produce hot water when the hot water is started, and you keep adjusting the switch at the shower faucet, causing the water from the shower faucet to be hot and cold, or even turn off.
You may be in this situation that the shower eye is blocked by dirty things, you remove the shower and then light the fire to try it, if it can be used normally, clean the shower eye and then install it.