How to test the purchased toilet

Toilets have a warranty period, and the toilet bowl you bought has product quality problems, so you can replace it with a new one directly, and you don't need to test it before.

First, the flushing method.

Nowadays, most toilets on the market are siphoned, which is easy to flush off the swag that adheres to the surface of the toilet. The disadvantage is that it is water-consuming and easy to block. It is not easy to clog directly and is easy to smell when it is disadvantaged.

Second, the effect of sewage discharge.

Flush check: Flush 3 times, at least 5 water-filled ping pong balls can be flushed. Also check the blowdown effect. Put in a piece of paper and drop a drop of ink, it should be drained at once without leaving a trace.

3. Touch the surface.

Gently touch the surface of the toilet bowl with your hands, if there is no uneven feeling, and the glaze and embryo feel are very delicate, the surface of the toilet bowl, its surface quality is better. If it is a low-to-medium grade toilet, the glaze and embryonic body on its surface will be rough, the color will be dull, and there will be small holes under the illumination of the light. Dig your hand deep into the stain, the inside should be smooth, rough and unglazed, and easy to leak.

Fourth, determine the pit distance.

Find out how the toilet drains its water horizontally into the wall or under the floor. Horizontal drain toilets must be clearly distanced (the distance between the center line of the toilet rear drain and the ground). The lower drain toilet must be clear about the pit distance.

Pit spacing refers to the distance between the center of the drain pipe of the toilet bowl and the wall. Generally, there are 300mm, 350mm, 400mm, 450mm, etc. Be sure to measure the pit distance first, and then choose the toilet with the pit spacing.

Observe whether the glaze on the surface of the toilet bowl is smooth.

You should also reach into the hole of the toilet bowl and feel the glaze inside. The inside of a bad toilet bowl is not even glazed. In addition, you should open the water tank to see the parts inside, and the toilet bowl is full of copper parts.

At least twenty or thirty years will not drip, run, leak! But many toilet tanks are filled with plastic parts.

In addition, it is recommended that you choose a connected toilet, which is easy to leak after a long time of separation.

Test suction The general store will provide a water test device, to PVC ball test, the manufacturer will generally use a lighter specific gravity casing and other water test, you can test with table tennis balls, towels and other things in the store.