Why can t my toilet pump automatically?

The reasons could be the following:

1.The water in the toilet bowl is broken or the parts in the toilet bowl are falling off.

2.The proper design of the toilet pipe type is not optimal.

3.Paper scraps or other clogging clogged it up.

Today we are going to talk about what we should do when the toilet is blocked by confetti or other blockages.

1.Buy a soft hook to unclog the pipe to hook up the blockage, and the toilet will naturally be able to drain.

2.Try to pass the hose down the toilet pipe with the hose of the pipe, try to stir up the blockage, if it is found that it is not easy to stir the material, then it proves that it is not easy to stir the material, so change the method.

3.Buy some caustic soda to try, boil the water, melt the caustic soda and pour it into the toilet. After ten minutes, it will be clear.

4.Fill the toilet bowl with water and then use a mop to block the toilet mouth, keep lifting it up and then poking it down, not too much, but with a strong and fast movement.

5.The easiest way is to go to the hardware store and buy a suction cup with a handle, and it will naturally pass after a few gasps.

6.If the toilet is blocked by mud or sand or hard objects, we will have to use a steel wire that can be bent and straightened to unclog the toilet.

1. The water pressure is too low.

There are many reasons why the toilet does not drain, but the first thing we consider is that the water pressure at home is too low, and then the water does not come, so it does not pump the water, which is the easiest fault to shoot.

2. Confetti is clogged.

We also need to consider whether it is blocked by some confetti or other debris, and if so, we can find a way to clean it up in time.

3. It may be that the filter screen is clogged with scale.

What is the reason why the toilet does not pump water, we can check whether it is a problem with the filter, there is a filter in the toilet water replenisher, which is easy to be blocked by scale after a long time, and the water cannot be pumped.

4. Is the toilet part falling off?

If none of the above reasons are true, we can see if the water inside the toilet is broken or the parts inside the toilet are falling off.

5. The inlet and outlet valves are faulty.

What is the reason why the toilet does not pump water, the toilet does not pump and the follow-up water valve has a close relationship with the outlet valve, which is likely to be caused by the failure of the inlet and outlet valves.

Is your home smart sensor or manual flushing? If it's smart sensing, see if the sensor head is dirty, if it's not dirty, it's broken! If it's manual, you press it down with your hand to see if there is a feeling of water pressure, if not, prove that there is no water in it, check whether the water is connected, if there is a water pressure sensation, it is blocked!

I won't get it, find someone outside to fix it! I have a complete set of Shuai Bang kitchen and bathroom utensils at home, and I can basically get a phone call if there is any problem! After-sales service is very important!

Next time, see it clearly, buy it again! It is recommended that you also check out the things in Shuaibang! Not bad indeed!

The service is very good!

The flush toilet is not really pumping, in fact, the tap water pipe is connected to the toilet tank through a float valve, and when the toilet tank is full, the float will resist the valve to automatically close the tap water.

The solution you said does not get into the water:

Check for tap water.

Open the lid of the tank and gently flick the float to see if it gets stuck and doesn't fall off.

If the float has fallen and no water has entered, and other faucets of the same hose have water, it means that the float valve is stuck inside and needs to be replaced.

It should be that the water valve is stuck, call someone to fix it.