-
Anonymous users2024-01-23Remove the pins on the pressure relief handle, remove the protective tab, and rotate the exposed slotted thread on the front half a turn clockwise to see if there is any dripping. If it is dripping, then screw it moderately until it does not leak; If there is no more dripping, you can rotate moderately until there is no dripping.
The safety valve indicates the pressure capacity, which is not very accurate. The above method refers to adjusting the pressure reducing valve threshold.
-
Anonymous users2024-01-22That fitting is called the safety valve, and if there is a problem with the safety valve, it is recommended to replace it.
-
Anonymous users2024-01-21Ask a professional to come to your home for repairs.
If the water in the bathroom is completely cold, it means that the water heater has not been ignited, there may be a blockage of the pipeline, and the water temperature is not high enough, which is generally caused by too far away, the hot water pipe is not insulated, and the temperature loss is too large during the flow of hot water.
Generally, the space of the bathroom must be at least 280 to install an electric water heater, and the upper part of the water heater should be left at least 20 to 30 cm from the top to prevent head collision or be installed outside the bathroom kitchen.
The gas water heater has hot water in the kitchen and the bathroom is not hot, this is because the hot water pipe in your home is too long, and the cold water in the pipe must be drained out first before the hot water can come out. Another reason is that you have to turn on the handle of the shower faucet on the side of the hot water, put it in the middle to turn on, and half of it is cold water, so the water in the bathroom is not hot, right?
1. Shower angle valve problem.
First check whether the shower angle valve in the bathroom is open, try to adjust the angle valve, and then wait a few minutes to test whether the water temperature is normal. If the water temperature is still cold after the angle valve is opened, check whether there is hot water in the pipeline. >>>More
This should not have anything to do with the water heater, it should be a problem with the installation of the water pipe, or the water pipe is small, the span is too long, there is a cold space in the middle, or the hot water pipe is not smooth, which may lead to this phenomenon. It is recommended to do a good job of insulating the hot water pipe, which may be better.