-
One is that you plug the sewer hose into the PVC sewer pipe more. The second is that the riser (where the hose is connected) of your PVC sewer is too short to cause backwater. The third is that the water outlet of your sewer pipe is not smooth, considering that it is the kitchen sewer (easy to have oil stains hanging on the inner wall of the sewer pipe), it is recommended that you rinse the sewer pipe with hot alkaline surface water.
-
If it doesn't work, find out the reason, whether it's blocked or the pipe is broken, blocked, broken or replaced!
-
Generally, an elbow will be installed under the kitchen sink, and this will not be the case with an elbow.
-
Take it apart, buy some raw material tape, wrap the thread around that joint, and then tighten it again!
-
Dredge it, it may be that the backwater bend below is a little blocked!
-
Normally, it should be that the sewer is blocked, and the water is not so fast, so it will gush out, and it will be good to pass the sewer pipe.
-
Develop good living habits, and do not casually dump waste water mixed with garbage.
Have a professional fix it up.
-
Wipe it dry, fill it with chewed gum, and then tape it so that it doesn't fall off and blocks the water.
The most important conveyor of kitchen sewage is an indispensable part of the kitchen. What do you do if your kitchen sink is leaking? First of all, we need to find out the exact cause of the leaking kitchen sink. >>>More
Start by identifying where the water is leaking. If it is only a joint leakage, under the premise that the quality of the pipe is qualified, the joint can be replaced or a leak-proof sealing tape and AB sealant can be added to the joint; If the quality of the pipe is not good, the pipe should be replaced. You can also apply the adjusted AB glue in the leaking place, and then wrap a layer of ribbon on it, so that the ribbon is soaked with AB glue and then apply a layer of AB glue on the ribbon, and the whole process can be divided into two or many times.
No matter what kind of glue, there can be no water when gluing, PVC glue, AB glue, tempered glue are recommended.
Waterproof rubber cloth: PTFE tape clean and dry the sealing surface, choose a certain width of PTFE sealing tape, tear off the adhesive tape protective paper, glue the sealing tape on the outer edge of the sealing surface, the two ends are overlapped at a certain bolt, and the intersection point is more than 2cm (Note: used on a flat flange, the two ends must be overlapped. >>>More
There is no responsibility problem for this, you can find the property to repair the leakage of the drain pipe, and you two will cooperate to repair it when repairing.