-
Anonymous users2024-01-23Common problem: surface cracking.
Surface cracking is generally caused by dry air, and shrinkage gaps generally use different methods depending on the size of the gap. That is, if the gap is large, you need to choose the same wooden strip according to the material of the furniture, repair the wooden strip to the size of the gap, and then stuff it into the gap; If the crack is small, you can drip 502 glue into the gap, fill it with some sawdust, and then use sandpaper to smooth the surface of the furniture filled with glue, repeatedly sandpaper sanding, and then wax until the surface of the furniture becomes smooth and flat. The post-processing method for barber filling is the same.
Common problem: furniture deformation.
If it is slightly deformed, this situation is generally smoothed with a grinder, and then sanded with sandpaper to smooth and wax. If the deformation is more severe, then it is necessary to "make a big move", you need to spray the deformed part with water, and then use a heat gun to completely heat this place, press a piece of straight and flat wood on it, fix the two ends with clamps, so that the surface of the two is completely in contact, so that the deformed wood becomes straight with the fixed plate for one to two days; If the deformation is particularly severe, it needs to be repeated 2-3 times. It should be noted that the hardness of the wood used for shaping must be greater than that of furniture wood, and the size of the shaping clip depends on the degree of deformation, and the baking gun also has liquefied gas and baking lamps to choose from, but the speed is different due to the different power sizes.
After the deformation is corrected, the subsequent procedure is sanding and waxing.
Common problem: loose mortise and tenon structure.
If the mortise and tenon structure is loose, you need to disassemble the mortise and tenon of the furniture again, put some glue on the inside of the furniture, and after reassembling, it is best to fix the copper or iron frame on the surface of the furniture, so that the mortise and tenon structure of the furniture will be very strong. Yuhongxuan mahogany furniture will answer for you! Hope it helps!
1. When placing mahogany furniture, pay attention to keeping the furniture away from the heat source, at least keeping a distance of about 1 meter. Mahogany furniture is too close to the heat source, which is easy to cause the evaporation of water in the mahogany to cause cracking of the furniture joints and the shrinkage of mortise and tenon. After the mortise and tenon joint is deformed, the panel is prone to cracking. >>>More
1. The poor quality of the glass itself is one of the reasons for the self-explosion of the glass, such as poor flatness, uneven thickness, and bubble slag inclusion in the glass. When exposed to the sun, the thermal effect is uneven, resulting in self-explosion. >>>More
The floor tiles were removed and re-waterproofed.
Toilet cleaner, sold in supermarkets, a bottle can be used for a long time, drop some into the toilet, and after a few minutes it will be clean with a brush lightly, which is very convenient and cheap.
Or go to the supermarket and buy a pipe pass, pour it in, and flush it with hot water.