-
Anonymous users2024-01-23Use a hand hammer or a small hand-held electric hammer to crush laterally. It is best to do it outdoors inwards if possible.
If the floor is higher, you can slowly make a groove of about 300 in the middle, and then break it from the edge of the balcony to both sides. At the same time, there is a full-time monitoring of the part of the balcony slab combined with the building, and if there are cracks, the construction will be stopped and evacuated.
Little taboo 1: the effect of temperature on flowers.
Temperature is very important for flowers, if it is in the north, it must be maintained indoors in winter to prevent the temperature from being too low to freeze the flowers to death. If it's summer, be careful to block the flowers from the sun, because the temperature in summer is too high, which may make the flowers exceed the temperature range it can bear, and the leaves will appear mushy. >>>More
The load-bearing design of the balcony is generally KN per square meter, and the load-bearing capacity of the balcony is about 200 kg per square meter. The ends of the balconies are also allowed to carry 1 kn per square meter, as the ends of the balconies can also carry 100 kg of concentrated load per linear meter. The load-bearing range of the balcony is divided into two kinds, one is the self-esteem of the balcony itself, and then the balcony increases after the change into the middle, the national implementation of the balcony load-bearing design standard is 250 kg per square meter, more than this standard will bring potential safety hazards.
The load-bearing load design of the balcony is generally (movable load) of 2KN square meters, that is, the balcony is missing about 200 kg per square meter; In addition, the end of the balcony is allowed to carry a load of 1 kn m, because this end of the balcony can also carry a concentrated live load of about 100 kg per linear m. >>>More
No, depending on the specific situation, the prefabricated floor slab is about 250 kg square, and the cast-in-place floor slab is about 400 kg square.
The load-bearing design of the balcony is generally KN per square meter, and the load-bearing capacity of the balcony is about 200 kg per square meter. The ends of the balconies are also allowed to carry 1 kn per square meter, as the ends of the balconies can also carry 100 kg of concentrated load per linear meter. The load-bearing range of the balcony is divided into two kinds, one is the self-esteem of the balcony itself, and then the balcony increases after the change into the middle, the national implementation of the balcony load-bearing design standard is 250 kg per square meter, more than this standard will bring potential safety hazards.