-
Anonymous users2024-01-23Gas water heaters are not easy to use, and the water flow rate should be considered first.
It is recommended to check the water output of the hot water faucet, if it is small, it may be a problem caused by insufficient water flow. Because gas water heaters are water-controlled and have a minimum water flow requirement, which is not met, the water heater cannot release gas and turn on the igniter, and cannot be used.
There are many reasons why gas water heaters are not good for ignition, and any component damage of water, gas, and electricity will cause the water heater to fail to ignite. But now the quality of water heater components is generally improved, not so easy to break, in fact, many times the reason why the fire can not be ignited is because of the fouling of the waterway caused by the blockage of the hot water pipeline, resulting in a large flow back pressure of the waterway, to a certain extent, the water heater water-gas linkage device can not open the gas channel, no gas, of course, can not catch fire, if the hot water faucet is fully open, the hot water pressure is smaller, the possibility is greater.
It is recommended to clean and descale immediately, you can buy a set of gas water heater without removing the scale device online, use it to inject descaling agent into the water heater to clean the inside of the water heater and the inside of the hot water pipeline, the operation is simple and convenient, and it can be cleaned regularly after use, when this problem can be avoided again.
-
Anonymous users2024-01-22Is the water pressure a little lower than that of the kitchen, and it may bend during the routing process?
-
Anonymous users2024-01-21The water output is small, check the water output.
No, the current gas chimney is a double flue outer flue to suck in the outside air, and the inner flue to exhaust the exhaust gas.
Do not rule out the possibility of water pressure (can be verified in two places without the output of the water heater, whether the water pressure in the two places is consistent), but the distance between the bathroom and the kitchen is not likely to cause water pressure problems (the two are very close), more attention should be paid to the indoor problems of the bathroom, if the bathroom is not ventilated (there is an exhaust outlet and there is no exhaust fan or there is an exhaust fan and the bathroom is too tight to get air), the oxygen supply is insufficient, carbon monoxide reflux and gas combustion is not comprehensive, not only affect the combustion heating, It can also lead to poisoning with water heaters.
The temperature of the heat exchange surface of the water heater is very high, and there will be scale when the water flows over, and after a long time, there will be a lot of scale attached to the surface of the heat exchanger, which will accumulate over time, causing the hot water pipeline to be blocked, which will cause the hot water output to become smaller (the phenomenon of small water pressure), the hot water output time will become longer, and it is not good to ignite and other problems. >>>More
There is an X3 in the Beverly X series, which has the function of kitchen washing++. One-key switch kitchen washing mode, you can choose 38 degrees fruit and vegetable washing, and 45 degrees high temperature degreasing washing. Very smart, which is also an exclusive feature of the X3.
Clean the pipes with vinegar, preferably for four or five hours in pipes that do not produce hot water, to ensure that it is effective.