How to dismantle the balcony pool if it is broken

Updated on Balcony 2024-02-13
1 answers
  1. Anonymous users2024-01-23

    If the pool is broken or broken, it is useless anyway, you can just smash it with a hammer a few more times and it will come down.

Related questions
4 answers2024-02-13

See what your pool is made of? In addition, the water leaks from the pool to the outside, or the water leaks from the outside into the pool. >>>More

15 answers2024-02-13

Step 1: The two loops shown in the picture are the positions of the two fixing holes, and there are two plastic nuts at the bottom of the toilet bowl to hold the two shafts in place, which can be seen from below. >>>More

2 answers2024-02-13

You will observe the spherical lock, the front of the keyhole is outside the door, the other end is the door, the end of the door near the back cover where there is a small hole, there is a protrusion inside, you take a small screwdriver to push the protrusion inward, and at the same time the spherical object back back, you can remove the back ball, and then reverse twist the back cover, and remove it, and then you take a Phillips screwdriver to unscrew the round spacer, so that you will just open the spherical trivial disassembly! Now you can start to install the lock: you put the tongue of the lock (that is, the cylindrical object on the top of the box on it, and there is a square iron sheet with two holes on the top of it) into the hole on the side of the door, and then take the ball in front of it in your hand, and put the other end in the hole outside the door and stuff it into the room, and at the same time make the gap in the lock body align with the fork behind the lock tongue, and then buckle the round gasket after stuffing it into place, and tighten the screws, then screw the back cover, and finally, align the back ball with the lock and push it on. When pushing up, you should also turn it slightly clockwise, and remember that there is also a small gap in the back ball, and you should aim it in the direction of the small hole with a protrusion! >>>More

12 answers2024-02-13

1. First unplug and turn off the power. Do cracks.

2. Secondly, unplug the rectifier and remove the spring. >>>More

4 answers2024-02-13

First, suck down the gusset next to it with a suction cup, and you can see the keel, and then it is convenient to remove the lamp. My family bought a drizzle sunshine LED square lamp, and it was okay to use, and the bulb has never been broken.