-
Anonymous users2024-01-23Generally, there is a hook around the lampshade of the square ceiling lamp to talk about the lampshade on the low plate of the lamp, you touch it counterclockwise with your hand on the roof, you should be able to touch the judgment skin, open the four hooks, you can see the lamp and the lamp card = mouth, dig the difference to remove the bulb and replace it.
-
Anonymous users2024-01-22Like this fixture, this plastic cover on the outside is a movable one – there are a few clips that get stuck and you can take your time.
Version of a corner on the right, see where the card is, and then press the card to open a place - generally a total of four bayonets, pay attention to unloading.
The lamp in the middle is also plugged in, press the base with one hand, grasp the center of the lamp with the other, and pull it down vertically.
-
Anonymous users2024-01-21Go to the shop that sells the light and buy a new bulb and the staff will install it for you.
-
Anonymous users2024-01-20You move the edge of the lampshade down, and the lampshade is replaced with a lampshade of the same model when you buy it, and you just need to cover the lampshade.
Hello On the four straight sides of the lamp, there is a right-angle slide plug (reach out to the lamp around and touch it), break the four slides outward, the lampshade will be taken off, and you will naturally install it.
Check if the lamp is not broken before cutting off the power supply to prevent electric shock, and then remove the lampshade, check whether the lamp joint is loose, turn on the lamp after tightening, if it is on, it means that it is caused by poor contact, if it is still not lit, you can check whether the lamp joint is black and dark, if there is, you can basically determine that it is a problem with the lamp, just remove the old lamp and replace it with a new lamp. >>>More
The lampshade is buckled up, grab both sides and pull down.
Just take two pieces off the ceiling and you're good to go.
On both sides is a spring card, you can cancel it by deducting it down, if you just change the lamp tube, you can see the place where there is PRESS on the lampshade, press the transparent lampshade outside and it opens, I open the lamp shop, you can ask me if you have any questions.