-
Anonymous users2024-01-231. If it is a special-shaped structure of architecture and a slope top, then it can be suspended according to the situation.
2.If the building is insufficient, the roof is uneven, or there is a slight slope, depending on the size of the slope. LESS THAN 2CM, YOU CAN USE GYPSUM AND PUTTY LEVELING, IF IT IS GREATER THAN 3CM, IT IS RECOMMENDED TO HANG PLASTERBOARD OR SHAPE THE TOP TO COVER UP.
If you don't pay attention to the flat roof, there will be wavy, sinking in the middle or uneven flat roof. There are many reasons for this phenomenon, mainly the following:
1) Accurately measure the horizontal baseline four weekends before hanging the flat roof, or do not make corners according to the horizontal baseline.
2) The end of the boom in the middle of the flat roof is adjusted upward, not only does not arch, but sinks because the middle boom bears the large load of the middle of the flat roof.
3) The distance between the booms is large or the keel cantilever distance is too large, and the deflection generated by the force of the keel causes the flat top to fluctuate.
4) The wooden boom splitting did not work.
5) The boom is not carefully adjusted, and the local boom is unevenly stressed, or even not stressed.
6) The wooden keel is deformed, and the bending of the light steel keel is not adjusted.
7) The joints of the flat top cover panel of the concealed frame are thickly embedded, causing the joints to protrude and form a flat roof undulation.
Therefore, before hanging the flat ceiling, the materials used must be selected, checked and sorted, and the materials that do not meet the requirements must be eliminated. During construction, the horizontal line is measured on the surrounding walls according to the height determined by the flat roof. According to the materials used in the bay and flat roof of the room, determine the material and arrangement spacing of the boom, and the horizontal spacing of the boom is 900 1200mm.
When installing the keel, special attention should be paid to the distance between the keel overhangs should not be greater than 300mm. Booms should be added at the joints of the two main keels. When the boom and keel are adjusted, the arch should be raised in the middle part, and the arch is generally 1 2OO according to the short span of the room.
When the concealed frame is flat on the fixed cover panel, the screw tail should not be exposed, and after the seam is embedded and pasted, the full batch should be carried out to make the seam of the cover panel form a plane with the middle part. After the construction of the flat roof is completed, it should be avoided from moisture, especially the lightweight flat roof.
-
Anonymous users2024-01-22Generally, you will be brushed with putty when you make the wall, and the painter will re-scrape it for you when you are making putty. The ceiling is generally a wooden keel or light steel keel base and then a gypsum board ceiling, and the shape of the ceiling can be modeled according to the designer's drawings.
Isn't that what the bricklayer does?
Second, I would like to reply to your three questions.
1) Toilet du: I see. >>>More
There is nothing that can be done about it already renovated.
Then don't do the decoration of the top surface, just scrape the wall paint. If you like it, you can also use wallpaper to stare at it, and you can use wood grain veneer or something. But if you have a beam in your house, you can hang the roof a little and decorate it.
Nowadays, people always think that the more complicated the better, but they don't know that this is not only expensive, but also redundant. In fact, the simplest decoration is to use gypsum line, and it is also the simplest ceiling. >>>More