The water in the TOTO toilet repair tank always leaks into the urinal, so it s a waste of water

The sealing rubber ring is damaged, there is always a sealing rubber ring when connecting the water tank, this sealing rubber ring is generally at the interface position of the water pipe, directly close the main water valve, and then unscrew the leaking interface position, and directly replace a sealing rubber ring.

It may be that the lower gasket of the drain is broken, or it may be caused by impurities that are not tightly sealed for a long time, clean it and try it.

There are three common reasons for a leak outside the toilet tank , the workaround is as follows:

1. Possible cause: The nut of the inlet valve is not tightened

Solution: Tighten the inlet valve nut.

2. Possible cause: the water stop plug connection is not tightened

Solution: Tighten the water stop plug.

3. Possible reasons: The buoyancy of the float (or floating bucket) is not enough

Solution: When the water submerges the float (or floating bucket), the inlet valve still cannot be closed, so that the water continues to flow into the water tank, and finally flows into the toilet from the overflow pipe and causes water leakage, replace the float (or floating bucket). The amount of buoyancy of the float (or float barrel), at least under pressure, the float is submerged 3 4 to ensure its sealing.

Generally, TOTO is an old-fashioned flush down type, and the water parts are generally based on the principle of levers, which is a waste of water. There are many causes of water leakage.

1. Water problems. Hold up the water piece by hand and float to the highest place, if the water no longer enters, it means that the water float is not set enough or damaged. As a result, the water cannot be stopped, and the excess water will flow into the toilet pipe through the overflow prevention.

2. The lower part of the water part and the toilet pipe are not well sealed, resulting in water leakage, which needs to be replaced.

3. There is trachoma in the lower part of the ceramic body of the water tank, which causes water leakage, and all the water needs to be emptied and the water inlet pipe needs to be closed. In general, the edge of the tank drain will be slightly higher than the bottom. There is a small part of the stored water, sprinkle some soot or similar small things that can float to test, if this part of the stored water can also cause water flow and leakage, then only let the manufacturer come, this is a product quality problem.

To see where the water leak is caused, open the lid of the water tank, is the water not floating? The water float can not float up and often leaks, and then the pipe fittings are damaged, the automatic water cut-off system of the water tank is very simple, and you can find and solve the problem by studying it!

Remove the part that puts water into the toilet, clean up the scale attached to it, and replace the seal if it is broken.

Relations between China and Japan are so tense, of course there will be problems with Japanese toilets.

Go to the domestic bathroom store to buy a new one, much more beautiful than your TOTO, the quality is not worse than it, the price is cheaper, and it is comfortable to use it yourself.

It is very likely that the water valve ball is out of order, and it should not be a big problem.

Water tank ball valve problem, see if this is caused by this, I hope it can help you.

The waterproof switch is stuck??

The drain valve cover is broken, and mine has the same problem.