Does the power switch socket of the air conditioner radiate to people at the head of the bed

Updated on Bedside 2024-01-28
3 answers
  1. Anonymous users2024-01-23

    Electrical outlets, which are not sources of radiation, do not cause harm to people.

  2. Anonymous users2024-01-22

    Where there is an electric current passing through, there is radiation.

  3. Anonymous users2024-01-21

    There is no radiation from the electrical outlets.

Related questions
1 answers2024-01-28

Try not to install a socket at the head of the bed, because the power supply is not safe after all, you can install a telephone socket, and the location is in a place that is not in the way (because the telephone socket is low-voltage electricity, there is no mandatory standard).

1 answers2024-01-28

Turn off the switch on the bathroom light.

First, pry the broken panel open with an electric pen (shell), and then remove the plastic buttons. >>>More

5 answers2024-01-28

As long as there is current, there will be radiation, but the radiation of sockets and switches is extremely small, negligible, and has no harm to the human body. >>>More

2 answers2024-01-28

The kitchen switch socket is sure to be very dirty and not too easy to clean up, and it is easier to choose the switch socket with better pollution resistance from the beginning, such as the Shang switch socket like Schneider Electric. In my own personal experience, I scraped some ash powder from the air conditioner outside the house and applied it to the surface of the water conditioner, and after the switch was erected, some of the ash powder fell off automatically very quickly. The residual ash powder can be cleaned and dried very quickly after being wiped lightly with a paper towel, and even if a marker is used to leave a mark on the surface of the switch, it can be wiped dry with a paper towel. The anti-fouling performance is very good. The key is that the switch can be covered with a D I Y side, and it is very easy to remove and clean.

2 answers2024-01-28

The height is higher than the bedside table and lower than the bedside, and the height of the bedside table is generally 55-58cm, so the socket position is set between 70-80cm, which is 10cm higher than the bedside table. >>>More